Automatic High Beam Control - Vehicles With: 12.3 Inch Instrument Cluster Display Screen
 WARNING: The system does not relieve you of your responsibility to drive with due care and attention. You may need to override the system if it does not turn the high beams on or off. WARNING: You may need to override the system when approaching other road users. WARNING: You may need to override the system during inclement weather. WARNING: Do not use the system in poor visibility, for example fog, heavy rain, spray or snow. WARNING: The system may not switch the high beams off if the lights of oncoming vehicles are hidden by obstacles, for example guard rails. WARNING: Inspect and replace the windshield wiper blades regularly to make sure the camera sensor has a clear view. The windshield wiper blades must be the correct length. |
About Automatic High Beam Control
The system is designed to turn the high beams on if all of the following occur:
- You switch the system on in the information display.
- You set the lighting control to the autolamps position.
- The ambient light level is low enough that high beams are required.
- There is no traffic in front of your vehicle.
- Your vehicle speed is greater than approximately 40 km/h (25 mph).
The system is designed to turn the high beams off if any of the following occur:
- You switch the system off in the information display.
- You set the lighting control to any position except autolamps.
- You switch the rear fog lamps on.
- The ambient light level is high enough that high beams are not required.
- The system detects an approaching vehicle's headlamps or rear lamps.
- The system detects severe rain, snow or fog.
- The system detects street lighting.
- The camera has reduced visibility.
- Your vehicle speed falls below approximately 30 km/h (19 mph).
Switching Automatic High Beam Control On or Off
- Press the menu button on the steering wheel to enter the information display main menu.
- Select Settings.
- Select Vehicle.
- Select Lighting.
- Switch Auto High Beam on or off.
Automatic High Beam Indicator
 It illuminates to confirm when the system is ready to assist. |
Overriding Automatic High Beam Control
Push the lever away from you to switch between high beam and low beam.
Automatic High Beam Control Information Messages
| Message | Description |
|---|---|
|
Front Camera Low Visibility Clean Screen |
The camera has reduced visibility.Clean the windshield.If the message continues to appear, have your vehicle checked as soon as possible. |
|
Front Camera Temporarily Not Available |
The camera has malfunctioned.Wait a short period of time for the camera to cool down.If the message continues to appear, have your vehicle checked as soon as possible. |
|
Front Camera Malfunction Service Required |
The camera has malfunctioned.Have your vehicle checked as soon as possible. |
Download Manual