Opening and Closing the Windows
Press the control to open the window. Lift the control to close the window.
Note: The power windows operate with the ignition on, and for several minutes after you switch the ignition off or until you open a front door.
To reduce wind noise or pulsing noise when one window is open, slightly open the opposite window.
One-Touch Open (If Equipped)
Fully press the window control and release it. Press again or lift it to stop the window.
One-Touch Close (If Equipped)
Fully lift the window control and release it. Press again or lift it to stop the window.
Resetting One-Touch Close
Carry out all steps within 30 seconds of starting the sequence.
- Fully open the window.
- Lift and hold the window control until the window is fully closed. Keep the window control held for a two seconds
- Press and hold the window control until the window is fully open. Keep the window control pressed for two seconds.
- Lift and hold the window control until the window is fully closed. Keep the window control held for a two seconds
Note: Repeat the procedure if the window does not close when you use one-touch.
Tailgate Window
To open the window, do the following:
- Open the tailgate. See Opening the Tailgate From Outside Your Vehicle.
- Lift the window.
To close the window, do the following:
- Push the window down.
- Close the tailgate. See Closing the Tailgate From Outside Your Vehicle.
What Is Global Opening
You can use the remote control to open the windows with the ignition off.
Using Global Opening
- Press and release the unlock button on the remote control.
- Press and hold the unlock button on the remote control.
- Release the button when the windows start to open.
Press the lock or the unlock button on the remote control to stop global opening.
Note: You can use global opening for a short period of time when you unlock your vehicle using the remote control.
Switching Global Opening On and Off
- From the settings menu, press Vehicle.
- Press Windows.
- Switch Remote Open on or off.
What Is Window Bounce-Back
The window stops and reverses if it detects an obstruction when closing.
Overriding Window Bounce-Back
- Close the window until it reaches the point of resistance and let it reverse.
- Lift and hold the window control switch within two seconds to override bounce-back and close the window.Bounce-back is now disabled and you can close the window manually.
Note: The window goes past the point of resistance and you can fully close it.
Note: If the window does not close, have your vehicle checked as soon as possible.