2022 Ford Bronco Owners Manual - Exterior Lighting

Exterior Lighting

EXTERIOR LIGHTING CONTROL

ALamps off.
BParking lamps on.
CAutolamps on.
DHeadlamps on.

Rotate the control to make a selection.

Note:   The lighting control defaults to autolamps every time you switch your vehicle on.

Headlamps

USING THE HIGH BEAM HEADLAMPS

Push the lever away from you to switch the high beam on.

Push the lever forward again or pull the lever toward you to switch the high beams off.

Slightly pull the lever toward you and release it to flash the headlamps.

HEADLAMP INDICATORS

Lamps On

Illuminates when you switch the low beam headlamps or the parking lamps on.

Headlamp High Beam

Illuminates when you switch the high beam headlamps on.

Headlamps – Troubleshooting

HEADLAMPS – FREQUENTLY ASKED QUESTIONS

Why is there condensation in the headlamps?

• Headlamps have vents to accommodate normal changes in air pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a fine mist can form on the interior of the lens. The fine mist eventually clears and exits through the vents during normal operation.

How much condensation is acceptable?

• The presence of a fine mist, for example no streaks, drip marks or large droplets. A fine mist covers less than 50% of the lens.

How long does it take for the acceptable condensation to clear?

• Clearing time can take as long as 48 hours under dry weather conditions.

How much condensation is unacceptable?

• A water puddle inside the lamp. Streaks, drip marks or large droplets present on the interior of the lens.

What should I do if unacceptable condensation is present?

• Have your vehicle checked as soon as possible.

Why do my headlamps turn off when I have them switched on when I switch my vehicle off?

• The battery saver turns the headlamps off after a short period of time after you switch your vehicle off.

Autolamps

WHAT ARE AUTOLAMPS

Autolamps turn the headlamps on in low light situations or when the windshield wipers operate.

AUTOLAMP SETTINGS

1. Press Settings on the touchscreen.

1. Press Vehicle Settings.

1. Press Lighting.

1. Press Autolamp Delay.

1. Press a setting.

Exterior Lamps

USING THE TURN SIGNAL LAMPS

Push the lever up or down to switch the turn signal lamps on.

Set the lever to the middle position to switch the turn signal lamps off.

Note:   Tap the lever up or down to make the turn signal lamps flash three times.

Turn Signal Lamp Indicator

It flashes when you switch the turn signal lamps on.

Note:   An increase in the rate of flashing warns of a failed turn signal lamp.

SWITCHING THE DAYTIME RUNNING LAMPS ON AND OFF - VEHICLES WITH: CONFIGURABLE DAYTIME RUNNING LAMPS

1. Press Settings on the touchscreen.

1. Press Vehicle Settings.

1. Press Lighting.

1. Switch Daytime Running Lights on or off.

The daytime running lamps turn on when all of the following occur:

• You switch the system on.
• You switch your vehicle on.
• The transmission is not in park (P) for vehicles with automatic transmissions or you release the parking brake for vehicles with manual transmissions.
• The lighting control is in the autolamps position.
• The headlamps are off.

Note:   Other lighting control positions do not turn on the daytime running lamps.

SWITCHING THE DAYTIME RUNNING LAMPS ON AND OFF - VEHICLES WITH: DAYTIME RUNNING LAMPS (DRL)

Daytime running lamps are always on unless you switch on the headlamps or your vehicle is in park (P).

USING THE FRONT FOG LAMPS (IF EQUIPPED)

To switch the lamps on or off:

1. Set the lighting control to the parking lamps, headlamps or autolamps position.

Note:   When the lighting control is in the autolamps position, you cannot switch the fog lamps on unless the low beam headlamps are on.

1.   Press the button on the lighting control to switch the front fog lamps on or off.

Note:   Only switch the front fog lamps on during reduced visibility.

Note:   The brightness of the daytime running lamps may decrease when the front fog lamps are switched on.

Front Fog Lamps Indicator

It illuminates when you switch the front fog lamps on.

SWITCHING THE SPOT LAMPS ON AND OFF (IF EQUIPPED)

The spot lamp buttons are near the lighting control.

Press the button to switch on the left-hand spot lamp.

Press the button to switch on the right-hand spot lamp.

Move the position of the exterior mirrors to adjust the aim.

Note:   Make sure you switch your vehicle on, with the vehicle in accessory mode or running.

Note:   The spot lamps turn off after 6 mph (10 km/h).

Note:   The spot lamps illuminate the area in front of and to the side of your vehicle.

SWITCHING OFF ROAD DRIVING LAMPS ON AND OFF - RAPTOR

The off-road driving lamps switch is connected to the AUX 1 switch on the auxiliary switch panel. When the switch is turned on, the indicator light on the switch illuminates and the circuit provides power to the off-road driving lights

Note:   Off-road driving lamps are for off-road use only. Use on public roads may violate local laws.

Note:   Only switch the off-road driving lamps on during reduced visibility in off-road conditions.

Note:   The off-road driving lamps only operate when accessory mode is active, and the engine is in the on or off position. Leave the engine running to maintain battery charge when using the off-road driving lamps.

EXTERIOR LAMP INDICATORS

Front Fog Lamp

It illuminates when you switch the front fog lamps on.

Turn Signal Lamp

  It flashes when you switch the turn signal lamps on.

Note:   An increase in the rate of flashing warns of a failed turn signal lamp.

EXTERIOR LAMPS ON AUDIBLE WARNING

Sounds when you open the driver door and the exterior lamps are on.