Indication lamps
Turn-signal indication lamps/ Hazard warning indication lamps
These indication lamps blink in the following situations.
► When the turn-signal lever is moved to activate a turn-signal lamp.
Refer to “Turn-signal lever”.
► When the hazard warning flasher switch is pressed to activate the hazard warning lamps.
Refer to “Hazard warning flasher switch”.
► When the hazard warning lamps automatically activate due to sudden braking while driving.
Refer to “Emergency stop signal system”.
Note
► If these indication lamps blink too fast due to any operation other than sudden braking, the cause may be a blown lamp bulb or a faulty turn-signal connection.
High-beam indication lamp
This indication lamp illuminates when the high-beam is used.
Front fog lamp indication lamp
This lamp illuminates while the front fog lamps are on.
Rear fog lamp indication lamp
This lamp illuminates while the rear fog lamp is on.
Position lamp indication lamp
This indication lamp illuminates while the position lamps are on.
ECO mode indicator (for vehicles equipped with CVT or Twin clutch SST)
Except for vehicles for Russia, Kazakhstan and Ukraine, this indicator will be displayed when fuel-efficient driving is achieved.
Diesel preheat indication lamp (diesel-powered vehicles)
This indication lamp illuminates when the ignition switch is placed in the “ON” position. As the glow plug becomes hot, the lamp goes out and the engine can be started.
Note
► If the engine is cold, the diesel preheat indication lamp is on for a longer time.
► When the engine has not been started within about 5 seconds after the diesel preheat indication lamp went out, return the ignition switch to the “LOCK” position.
Then, turn the switch to the “ON” position to preheat the engine again.
► When the engine is warm, the diesel preheat indication lamp does not come on even if the ignition switch is placed in the “ON” position.
Download Manual