Indication lamp, warning lamp, and information screen display list
Indication and warning lamp list
1. “Adaptive Front lighting System (AFS) warning lamp”
2. Position lamp indication lamp ®
3. High-beam indication lamp ®
4. Charge warning lamp ®
5. Turn-signal indication lamps/Hazard warning indication lamps ®
6. Front fog lamp indication lamp ®
7. Rear fog lamp indication lamp ®
8. Anti-lock brake system (ABS) warning lamp ®
9. Brake warning lamp ®
10. Cruise control indication lamp ®
11. Seat belt warning lamp ®
12. Supplement Restraint System (SRS) warning lamp ®
13. ECO mode indicator (Vehicles equipped with CVT or Twin clutch SST (except for vehicles for Russia, Kazakhstan and Ukraine)) ®
14. Check engine warning lamp ®
15. Active stability control (ASC) OFF indicator ®
16. Active stability control (ASC) indicator ®
17. Auto Stop & Go (AS&G) OFF indication lamp ®
18. Auto Stop & Go (AS&G) indication lamp ®
19. Diesel preheat indication lamp (diesel-powered vehicles) ®
20. Information screen display list ®
Information screen display list
When there is information to be announced, such as lamp reminders, a sound is emitted and the screen switches to the displays shown below. Refer to the appropriate page and take the necessary measures.
When the cause of the warning display is eliminated, the warning display goes out automatically.
Note
► A warning may be displayed on the information screen and the buzzer may sound in the following rare cases.
This is caused by the system picking up interference such as noise or strong electromagnetic waves, and is not a functional problem.
• An extremely strong electromagnetic wave is received from a source such as an illegal radio set, a spark from a wire, or a radar station.
• Abnormal voltage or a static electricity discharge is generated by the operation of installed electrical equipment (including after-market parts).
If the warning display appears many times, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
Warning display list (when the ignition switch is “OFF”)
Warning display list (when the ignition switch is “ON”)
Other interrupt displays (when the ignition switch is “ON”)
The operation status of each system is displayed on the information screen. Refer to the appropriate page for the system for further details.
This informs you that a periodic inspection is due.
The setting for rest interval can be changed.
Download Manual