2019 Jeep Grand Cherokee Owners Manual - IGNITION SWITCH

IGNITION SWITCH

Keyless Enter-N-Go — Ignition

This feature allows the driver to operate the ignition switch

dealer.

with the push of a button as long as the key fob is in the 3

Keys must be ordered to the correct key cut to match the vehicle locks.

General Information

The following regulatory statement applies to all radio frequency (RF) devices equipped in this vehicle:

This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, in- cluding interference that may cause undesired opera- tion.

NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

passenger compartment.

The Keyless Push Button Ignition has several operating modes that are labeled and will illuminate when in posi- tion. These modes are OFF, ACC, RUN, and START.

NOTE: If the ignition switch does not change with the push of a button, the key fob may have a low or dead battery. In this situation, a back up method can be used to operate the ignition switch. Put the nose side (side opposite of the emergency key) of the key fob against the ENGINE START/STOP button and push to operate the ignition switch.

START/STOP Ignition Button

The push button ignition can be placed in the following modes:

OFF

The engine is stopped.

Some electrical devices (e.g. Central locking, alarm, etc.) are still available.

ACC

Engine is not started.

Some electrical devices are available.

RUN

Driving position.

All the electrical devices are available.

START

The engine will start.

(Continued)

NOTE: The power window switches and power sunroof (if equipped) will remain active up to ten minutes after the ignition is cycled to the OFF position. Opening either front door will cancel this feature. The time for this feature is

programmable. 3

NOTE: Refer to "Starting The Engine," in "Starting And Operating" for further information.

When opening the driver’s door when the ignition is in RUN (engine not running), a chime will sound to remind you to place the ignition in the OFF position. In addition to the chime, the message will display “Ignition Or Accessory On” in the cluster.

(Continued)

The Remote Starting System also activates the Climate Control, vented seats (if equipped) in temperatures above 80° F (26.7° C), and the optional heated seats, and optional heated steering wheel in temperatures below 40° F (4.4° C). Refer to “Seats” in “Getting To Know Your Vehicle” for further information.

NOTE:

The vehicle must be equipped with an automatic trans- mission to be equipped with Remote Start.

Obstructions between the vehicle and key fob may reduce this range.