Parkview rear back up camera
Your vehicle is equipped with the Rear Back Up Camera that allows you to see an on-screen image of the rear surroundings of your vehicle whenever the gear selector is put into REVERSE. The image will be displayed on the touchscreen or if equipped, in the rearview mirror. If the image is displayed in the radio screen, a caution note to “Check Entire Surroundings” across the top of the screen. After five seconds this note will disappear. The Rear Back Up Camera is located on the rear of the vehicle, above the rear license plate.
When the vehicle is shifted out of REVERSE, the rear camera mode is exited and the last selected touchscreen appears again.
When the vehicle is shifted out of REVERSE with camera delay turned on, the rear camera image will be displayed for up to 10 seconds after shifting to another gear, unless the vehicle speed exceeds 8 mph (13 km/h), the transmission is shifted into PARK, the ignition is placed in the OFF position, or the touchscreen X button to disable display of the rear view camera image is pressed.
Note:
The programmable features of the Rear Back Up Camera can be selected through the touchscreen. Refer to “Radio 430/430 NAV” in “Multimedia” for further information.
When displayed, static grid lines will illustrate the width of the vehicle while a dashed center-line will indicate the center of the vehicle to assist with aligning to a hitch/receiver. The static grid lines will show separate zones that will help indicate the distance to the rear of the vehicle. The following table shows the approximate distances for each zone:
|
Zone |
Distance To The Rear Of The Vehicle |
|
Red |
0 - 1 ft (0 - 30 cm) |
|
Yellow |
1 ft - 3 ft (30 cm - 1 m) |
|
Green |
3 ft or greater (1 m or greater) |
WARNING:
Drivers must be careful when backing up even when using the ParkView Rear Back Up Camera. Always check carefully behind your vehicle, and be sure to check for pedestrians, animals, other vehicles, obstructions, or blind spots before backing up. You are responsible for the safety of your surroundings and must continue to pay attention while backing up. Failure to do so can result in serious injury or death.
CAUTION:
-
To avoid vehicle damage, ParkView should only be used as a parking aid. The ParkView camera is unable to view every obstacle or object in your drive path.
-
To avoid vehicle damage, the vehicle must be driven slowly when using ParkView to be able to stop in time when an obstacle is seen. It is recommended that the driver look frequently over his/her shoulder when using ParkView.
Note:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens, rinse with water, and dry with a soft cloth. Do not cover the lens.
Download Manual