Remote keyless entry system (if so equipped)
WARNING
|
It is possible to lock/unlock all doors, turn the interior lights on, and activate the panic alarm by using the keyfob from outside the vehicle.
Be sure to remove the key from the vehicle before locking the doors. The keyfob can operate at a distance of approximately 33 ft (10 m) from the vehicle. The effective distance depends on the conditions around the vehicle.
As many as four keyfobs can be used with one vehicle. For information concerning the purchase and use of additional keyfobs, contact a NISSAN dealer.
The keyfob will not function when:
- the battery is discharged
- the distance between the vehicle and the keyfob is over 33 ft (10 m)
The panic alarm will not activate when the key is in the ignition switch.
| CAUTION
Listed below are conditions or occurrences which will damage the keyfob:
If a keyfob is lost or stolen, NISSAN recommends erasing the ID code of that keyfob. This will prevent the keyfob from unauthorized use to unlock the vehicle. For information regarding the erasing procedure, please contact a NISSAN dealer. |
How to use remote keyless entry system
Locking doors
- Remove the ignition key.
- Close all the doors.
- Push the LOCK
button on the keyfob.
- All the doors will lock.
- The hazard indicator flashes twice and the horn beeps once .
NOTE: An auto-relock function will operate after a full or partial unlock, when no further user action occurs. The relock will operate approximately one minute after full or partial unlock. The auto-relock function is cancelled when any door is opened or the key is inserted into the ignition.
Unlocking doors
- Press the UNLOCK
button on the keyfob to unlock the driver’s door. - The hazard warning lights flash once.
- Press the UNLOCK
button again within five seconds to unlock all doors.
Using the panic alarm
If you are near your vehicle and feel threatened, you may activate the panic alarm to call attention by pressing and holding the 
button on the keyfob for longer than 0.5 seconds.
The panic alarm will stay on for a period of time.
The panic alarm stops when:
- it has run for a period of time, or
- any button is pressed on the keyfob.
Using the interior light
Press the button on the keyfob once to turn on the interior lights.
For additional information, refer to “Interior light” in the “Instruments and controls” section in this manual.
Answer back horn feature
If desired, the answer back horn feature can be deactivated using the keyfob. When deactivated and the LOCK 
button is pushed the hazard indicator flashes twice and when the UNLOCK 
button is pushed, neither the hazard indicator nor the horn operates.
NOTE: If you change the answer back horn and light flash feature with the keyfob, the vehicle information display screen will show the current mode after the ignition switch has been cycled from the OFF to the ON position. The vehicle information display screen can also be used to change the answer back horn mode. For additional information, refer to “Answer back horn” in the “Instruments and controls” section of this manual.
To deactivate: Press and hold the and buttons for at least two seconds.
The hazard warning lights will flash three times to confirm that the answer back horn feature has been deactivated.
To activate: Press and hold the and buttons for at least two seconds once more.
The hazard warning lights will flash once and the horn will sound once to confirm that the horn beep feature has been reactivated.
Deactivating the horn beep feature does not silence the horn if the alarm is triggered.
Download Manual