POWER SUNROOF — IF EQUIPPED
The power sunroof switch is located between the sun visors on the overhead console.
Power Sunroof Switch OPENING AND CLOSING THE SUNROOF
Push the switch rearward and release it within one-half second and the sunroof will open automatically from any position. The sunroof will open fully and stop automatically.
Push the switch forward and release it within one-half second and the sunroof will close automatically from any position. The sunroof will close fully and stop automatically.
During Express Open or Express Close operation, any other movement of the sunroof
To open the sunroof, push and hold the switch rearward to full open.
To close the sunroof, push and hold the switch in the forward position.
Any release of the switch during open or close operation will stop the sunroof movement.
The sunroof will remain in a partially opened position until the switch is operated and held again.
This feature will detect an obstruction in the closing of the sunroof during the Express Close operation. If an obstruction in the path of the sunroof is detected, the sunroof will automatically retract. Remove the obstruction if this occurs.
If three consecutive sunroof close attempts result in Pinch Protect reversals, Pinch Protect will disable and the sunroof must be closed in Manual mode.
(Continued)
switch will stop the sunroof.
Push and release the Vent button within
one-half second and the sunroof will open to the vent position. This is called “Express Vent” and it will occur regardless of sunroof position.
During Express Vent operation, any movement of the switch will stop the sunroof.
The sunshade can be opened manually. However, the sunshade will open automatically as the sunroof opens.
The sunshade cannot be closed if the sunroof is open.
Use only a non-abrasive cleaner and a soft cloth to clean the glass panel. Periodically check for and clear out any debris that may have collected in the tracks.
The power sunroof switch can remain active in Accessory Delay for up to approximately
10 minutes after the vehicle’s ignition is placed
to the OFF position. Opening either front door will cancel this feature.
This feature is programmable using the Uconnect system page 138.
Download Manual