2015 Toyota Land Cruiser Owners Manual - Theft deterrent system

Theft deterrent system

The vehicle’s keys have built-in transponder chips that prevent the engine from starting if the key has not been previously registered in the vehicle’s on-board computer.

Never leave the keys inside the vehicle when you leave the vehicle.

• Vehicles with navigation system

The indicator light flashes after the “ENGINE START STOP” switch has been turned OFF to indicate that the system is operating.

The indicator light stops flashing after the “ENGINE START STOP” switch has been turned to ACCESSORY or IGNITION ON mode to indicate that the system has been canceled.

• Vehicles without navigation system

• System maintenance

   

The vehicle has a maintenance-free type engine immobilizer system.

• Conditions that may cause the system to malfunction

   

• If the key is in contact with a metallic object.
• If the key is in close proximity to or touching a key to the security system (key with a built-in transponder chip) of another vehicle.

• Certifications for the engine immobilizer system

   

FCC ID: NI4TMIMB-1

NOTE

: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Alarm

The system sounds the alarm and flashes lights when forcible entry is detected.

•  Triggering of the alarm

   

The alarm is triggered in the following situations when the alarm is set:

•  A locked door is unlocked or opened in any way other than by using the smart key system, the wireless remote control or using the mechanical key. (The doors will lock again automatically)
•  The hood is opened.
•  The battery is reconnected.

•  Setting the alarm system

   

• Vehicles with navigation system

Close the doors and hood, and lock all doors.

The system will be set automatically after 30 seconds.

The indicator light changes from being on to flashing when the system is set.

• Vehicles without navigation system

• Deactivating or stopping the alarm

   

Do one of the following to deactivate or stop the alarm.

•  Unlock the doors.
•  Turn the “ENGINE START STOP” switch to ACCESSORY or IGNITION ON mode, or start the engine. (The alarm will be deactivated or stopped after a few seconds.)

• System maintenance

   

The vehicle has a maintenance-free type alarm system.

• Items to check before locking the vehicle

   

To prevent unexpected triggering of the alarm and vehicle theft, make sure of the following.

• Nobody is in the vehicle.
• The windows and moon roof are closed before the alarm is set.
• No valuables or other personal items are left in the vehicle.

• Triggering of the alarm

   

The alarm may be triggered in the following situations.

(Stopping the alarm deactivates the alarm system.)

• A person inside the vehicle opens a door or hood.

• The battery is recharged or replaced when the vehicle is locked.

• When the battery is disconnected

   

Be sure to cancel the alarm system.

If the battery is disconnected before canceling the alarm, the system may be triggered when the battery is reconnected.

• Alarm-operated door lock

   

• When the alarm is operating, the doors are locked automatically to prevent intruders.
• Do not leave the key inside the vehicle when the alarm is operating, and make sure the key is not inside the vehicle when recharging or replacing the battery.

• Panic mode

   

When  is pressed for longer than about one second, the headlights/tail lights/emergency flashers will flash, the front and rear interior lights will come on, and an alarm will sound for about 60 seconds to deter any person from trying to break into or damage your vehicle.

To stop the alarm, press any button on the wireless remote control.