2019 Ford Fiesta Owners Manual - Changing the Rear Wiper Blades

Changing the Rear Wiper Blades

1. Lift the wiper arm.

Note:   Do not hold the wiper blade to lift the wiper arm.

1. Disengage the wiper blade from the wiper arm.

Note:   Make sure that the wiper arm does not spring back against the glass when the wiper blade is not attached.

1. To install, reverse the removal procedure.

Note:   Make sure that the wiper blade locks into place.

Removing a Headlamp

WARNING:  Switch the lamps and the ignition off. Failure to do so could result in serious personal injury.

1. Use a suitable tool, for example a screwdriver, to carefully remove the trim clip.

Note:   Raise the center pin and then remove the clip.

1. Remove the screws.

1. Place your hand below the headlamp housing and lift the headlamp at the center area to disengage the lower fixing clip.

1. Carefully lift the headlamp up at the front and rear to disengage it from the fixing points.

Note:   Take care when removing the headlamp. There are rupture points adjacent to the securing screws that are designed to separate under impact.

1. Slightly rotate the rear of the headlamp toward the center of the vehicle so that it clears the front fender.

1. Move the headlamp slightly backwards to clear the radiator grille panel. Then lift the headlamp straight upward.

1. Disconnect the electrical connector.

1. Remove the headlamp.

1. To install, reverse the removal procedure.