Engine Coolant
Park the vehicle on level ground. Check the reserve tank and the coolant level in the radiator. We recommend Honda Long Life Antifreeze/Coolant Type 2.
Checking the Reserve Tank
- Check the amount of coolant in the reserve tank.
- If the coolant level is below the MIN mark, add the specified coolant until it reaches the MAX mark.
- Inspect the cooling system for leaks.
If Honda antifreeze/coolant is not available, you may use another major brand non-silicate coolant as a temporary replacement. Check that it is a high quality coolant recommended for aluminum engines. Continued use of any non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail. Have the cooling system flushed and refilled with Honda antifreeze/coolant as soon as possible.
Adding Coolant
- Make sure the engine and radiator are cool.
- Turn the radiator cap counterclockwise and relieve any pressure in the coolant system. Do not push the cap down when turning.
- Push down and turn the radiator cap counterclockwise to remove it.
- The coolant level should be up to the base of the filler neck. Add coolant if it is low.
- Put the radiator cap back on and tighten it fully.
- Pour coolant into the reserve tank until it reaches the MAX mark. Put the cap back on the reserve tank.
Removing the radiator cap while the engine is hot can cause the coolant to spray out, seriously scalding you.
Always let the engine and radiator cool down before removing the radiator cap.
Pour the fluid slowly and carefully so you do not spill any. Clean up any spills immediately, they can damage components in the engine compartment.
Download Manual