Wiper and washer switch
Windshield wipers
The windshield wipers wipe when the wiper lever is moved as shown in the illustration and the ignition key is in the “ON” or “ACC” position.
To adjust intermittent intervals
With the lever in the “INT” (speed-sensitive) position, the intermittent intervals can be adjusted by turning the knob (A).
MIST- Misting function The wipers will wipe one time.
OFF- Off INT- Speed sensitive intermittent operation
Interval between wiper sweeps varies in accordance with vehicle speed.
LO- Slow HI- Fast
1- Fast 2- Slow
Features and controls
Misting function
Move the lever in the direction of the arrow and release, and the wipers will operate once. Use this function when you are driving in mist or drizzle. If the lever is held in the upward position (MIST), the wipers continue operating until the lever is released.
Windshield washer
To turn on the windshield washer, pull the lever toward you with the ignition key in either the “ON” or “ACC” position. The wipers will wipe automatically several times when the washer fluid is sprayed. To turn off the spray, release the lever.
Features and controls
Rear window wiper and washer (ECLIPSE only)
The rear window wiper and washer can be operated when the ignition key is in the “ON” or “ACC” position. Turn the knob to operate the rear window wiper.
NOTE
● To ensure a clear rearward view, the wiper performs a number of continuous operations either when the switch is moved to the “INT” position or when the gearshift lever (manual transmission) or the selector lever (automatic transmission) is moved to the “R” (REVERSE) position while the switch is in the “INT” position. Following this continuous operation, the wiper will auto- matically switch to intermittent operation.
● The washer fluid reservoir is located in the engine com- partment. Check the fluid level regularly and refill if necessary. (See “Washer fluid” on page 7-14.)
Precautions to observe when using wipers and washers
NOTE ● Do not use the wipers when the windshield is dry. This could scratch the glass and wear the wiper blades prema- turely.
● Before using the wipers in cold weather, check to be sure that the wiper blades are not frozen to the windshield or rear window. Using the wipers while the blades are frozen could cause the wiper motor to burn out.
OFF- Off INT- The wiper operates continuously for several seconds then
operates intermittently at intervals of about 8 seconds. - Washer fluid will be sprayed onto the rear window glass
while the knob is turned fully in either direction. When the washer fluid is sprayed, the wiper will automati- cally operate 2 or 3 times.
CAUTION! ● If the washer is used in cold weather, the washer
fluid sprayed onto the glass might freeze, blocking your view. In cold weather, heat the glass with the defroster before using the washer.
Features and controls
● If the wipers become blocked by ice or other deposits on the glass, the motor may still burn out even if the wiper switch is OFF. If deposits form on the windshield, park your vehicle in a safe place, turn off the engine, and clean the glass so that the wipers can operate smoothly.
● Avoid using the washer for more than 20 seconds at a time. Do not operate the washer when the fluid reservoir is empty or the pump may fail.
● During cold weather, add a recommended washer solution that will not freeze in the washer reservoir. Otherwise the washer may not work or may be damaged.
● Replace the wiper blades when they are worn. Use the proper size replacement blades. If you have questions, ask your authorized Mitsubishi Motors dealer.
Download Manual