Antenna
Antenna
Removing the antenna
Place the included wrench
1
around the antenna.
When not in use, the wrench is
stored in glove box.
Loosen the antenna with the
2
wrench and remove it.
Installing the antenna
Tighten the antenna by one
1
hand until it will not turn any
more.
Using the wrench, tighten the
2
antenna an additional 1/8th turn
(20 to 45 degrees) to secure it
in place.
After tightening the antenna,
remove the wrench.
401
About the wrench
After using the included wrench, store it in the glove box for safekeeping.
NOTICE
To avoid damaging the antenna
Remove the antenna in the following situations.
When using an automatic carwash.
When the antenna will touch the ceiling of a garage, etc.
When covering the vehicle with a car cover.
Removing the antenna
For normal driving, make sure the antenna is installed.
When removing the antenna to use an automatic carwash, etc., be careful
not to lose the antenna. Also, make sure to reinstall the antenna before
driving the vehicle.
Using the wrench
When installing or removing the antenna, use the included wrench.
Be careful not to scratch or damage the vehicle body with the wrench.
Do not over-tighten the antenna.
5
Over-tightening may damage the antenna.
Do not use any tools other than the included wrench to install or remove
the antenna.
Otherwise damage may result on the antenna’s finish.
Download Manual