Disclaimer: Not affiliated with or endorsed by Toyota Motor Company. For informational purposes only. Full Disclaimer

2022 Toyota Sequoia Owners Manual - Specifications



Specifications

*1: The model code is indicated on the Certification Label. (P. 524)

Weight

Model code*1 Engine Driving system

Vehicle capac- ity weight

(Occupants +luggage)

TWR* (Trailer weight

+ cargo) USK60L- GKTSKA

5.7 L V8 (3UR-FE)

engine

2WD

1320 lb. (600 kg)

7400 lb. (3357 kg)

USK60L- GKTLKA

1305 lb. (590 kg) 7200 lb.

(3266 kg)USK60L- GKTZKA

1320 lb. (600 kg)

USK65L- GKTSKA

4WD

1290 lb. (585 kg) 7100 lb.

(3220 kg)USK65L- GKTLKA

1250 lb. (565 kg)

USK65L- GKTZKA

1265 lb. (575 kg)

7000 lb. (3175 kg)

*:This model meets the tow-vehicle trailering requirement of SAE International per SAE J2807.

Vehicle identification number

The vehicle identification number (VIN) is the legal identifier for your vehicle. This is the primary identification number for your Toyota. It is used in registering the ownership of your vehicle. This number is stamped on the top left of the instrument panel.

This number is also on the Cer- tification Label.

Engine number

The engine number is stamped on the engine block as shown.

Vehicle identification

5258-1. Specifications

8

Vehicle specifications

SEQUOIA_OM_USA_OM0C047U

Engine

Model 3UR-FE Type 8-cylinder V-type, 4-cycle, gasoline Bore and stroke 3.70  4.02 in. (94.0  102.0 mm) Displacement 345.6 cu.in. (5663 cm3) Valve clearance (engine cold) Automatic adjustment

Drive belt tension Automatic adjustment

Fuel

Fuel type Unleaded gasoline only Octane rating (Unleaded gasoline)

87 (Research Octane Number 91) or higher

Fuel tank capacity (Reference) 26.4 gal. (100.0 L, 22.0 lmp.gal.)

526 8-1. Specifications

SEQUOIA_OM_USA_OM0C047U

*: The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick.

Engine oil selection

“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toyota approved “Toyota Genuine Motor Oil” or equivalent to sat- isfy the following grade and viscosity. Oil grade: ILSAC GF-6A multigrade engine oil Recommended viscosity: SAE 0W-20 SAE 0W-20 is the best choice for good fuel economy and good starting in cold weather. If SAE 0W-20 is not available, SAE 5W-20 oil may be used. However, it must be replaced with SAE 0W-20 at the next oil change.

Lubrication system

Oil capacity (Drain and refill  reference*) With filter Without filter

8.5 qt. (8.0 L, 7.0 Imp.qt.) 7.9 qt. (7.5 L, 6.6 Imp.qt.)

Outside temperature

5278-1. Specifications

8

Vehicle specifications

SEQUOIA_OM_USA_OM0C047U

Oil viscosity (0W-20 is explained here as an example): • The 0W in 0W-20 indicates the characteristic of the oil which

allows cold startability. Oils with a lower value before the W allow for easier starting of the engine in cold weather.

• The 20 in 0W-20 indicates the viscosity characteristic of the oil when the oil is at high temperature. An oil with a higher viscosity (one with a higher value) may be better suited if the vehicle is operated at high speeds, or under extreme load conditions.

How to read oil container label: The International Lubricant Speci- fication Advisory Committee (ILSAC) Certification Mark is added to some oil containers to help you select the oil you should use.

528 8-1. Specifications

SEQUOIA_OM_USA_OM0C047U

Cooling system

Capacity Vehicles without towing package

13.1 qt. (12.4 L, 10.9 Imp.qt.) Vehicles with towing package

14.1 qt. (13.3 L, 11.7 Imp.qt.)

Coolant type

Use either of the following: • “Toyota Super Long Life Coolant” • A similar high-quality ethylene glycol-

based non-silicate, non-amine, non- nitrite, and non-borate coolant with long-life hybrid organic acid technol- ogy

Do not use plain water alone.

Ignition system

Spark plug Make Gap

DENSO SK20HR11 0.043 in. (1.1 mm)

NOTICE ■ Iridium-tipped spark plugs

Use only iridium-tipped spark plugs. Do not adjust the spark plug gap.

Electrical system

Battery

Open voltage at 68 °F (20 °C):

12.6  12.8 V Fully charged 12.2  12.4 V Half charged 11.8  12.0 V Discharged (Voltage checked 20 minutes after the engine and all the lights are turned off.)

Charging rates 5 A max.

5298-1. Specifications

8

Vehicle specifications

SEQUOIA_OM_USA_OM0C047U

*: Your Toyota vehicle is filled with “Toyota Genuine Differential Gear Oil” at the factory. Use Toyota approved “Toyota Genuine Differential Gear Oil” or an equivalent oil of matching quality to satisfy the above specification. Please contact your Toyota dealer for further details.

*: The fluid capacity is a reference quantity. If replacement is necessary, con- tact your Toyota dealer.

Transfer (4WD models)

Oil capacity 1.43 qt. (1.35 L, 1.19 Imp.qt.) Oil type Gear oil API GL-5 Recommended oil viscosity SAE 75W-90

Differential

Oil capacity Front (4WD models) 2.17 qt. (2.05 L, 1.80 Imp.qt.)

Rear 1.64 qt. (1.55 L, 1.36 Imp.qt.)

Oil type and viscosity* Toyota Genuine Differential Gear Oil LT 75W-85 GL-5 or equivalent

Automatic transmission

Fluid capacity* 11.7 qt. (11.1 L, 9.8 Imp.qt.) Fluid type Toyota Genuine ATF WS

NOTICE

■Transmission fluid type

Using transmission fluid other than the above type may cause abnormal noise or vibration, or damage the transmission of your vehicle.

530 8-1. Specifications

SEQUOIA_OM_USA_OM0C047U

*1: Minimum pedal clearance when depressed with a force of 110 lbf (490 N, 50 kgf) while the engine is running.

*2: Parking brake pedal travel when depressed with a force of 67.1 lbf (300 N, 30.6 kgf).

Brakes

Pedal clearance*1 4.1 in. (104 mm) Min. Pedal free play 0.04  0.24 in. (1  6 mm) Brake pad wear limit 0.04 in. (1.0 mm) Parking brake lining wear limit 0.04 in. (1.0 mm) Parking brake pedal travel*2 6  9 clicks Fluid type FMVSS No.116 DOT 3 or SAE J1703

Steering

Free play Less than 1.2 in. (30 mm)

Power steering fluid type Automatic transmission fluid DEXRON® II or III

5318-1. Specifications

8

Vehicle specifications

SEQUOIA_OM_USA_OM0C047U

 Type A

 Type B

 Spare tire (Type A)

 Spare tire (Type B)

Tires and wheels

Tire size P275/65R18 114T Tire inflation pressure (Recommended cold tire inflation pressure)

Front tires: 33 psi (230 kPa, 2.3 kgf/cm2 or bar) Rear tires: 33 psi (230 kPa, 2.3 kgf/cm2 or bar)

Wheel size 18  8J Wheel nut torque 97 ft·lbf (131 N·m, 13.4 kgf·m)

Tire size P275/55R20 111H Tire inflation pressure (Recommended cold tire inflation pressure)

Front tires: 30 psi (210 kPa, 2.1 kgf/cm2 or bar) Rear tires: 33 psi (230 kPa, 2.3 kgf/cm2 or bar)

Wheel size 20  8J Wheel nut torque 97 ft·lbf (131 N·m, 13.4 kgf·m)

Tire size P255/70R18 112T Tire inflation pressure (Recommended cold tire inflation pressure)

33 psi (230 kPa, 2.3 kgf/cm2 or bar)

Wheel size 18  8J Wheel nut torque 154 ft·lbf (209 N·m, 21.3 kgf·m)

Tire size P275/65R18 114T Tire inflation pressure (Recommended cold tire inflation pressure)

33 psi (230 kPa, 2.3 kgf/cm2 or bar)

Wheel size 18  8J Wheel nut torque 154 ft·lbf (209 N·m, 21.3 kgf·m)

532 8-1. Specifications

SEQUOIA_OM_USA_OM0C047U

A: Wedge base bulbs (clear) B: Wedge base bulbs (amber) C: Double end bulbs

Light bulbs

Light Bulbs Bulb No. W Type

Exterior

Stop/tail and rear side marker lights 7443 21/5 A

Rear turn signal lights — 21 B Tail lights 194 3.8 A Back-up lights 921 16 A License plate lights 168 5 A Outer foot light (if equipped) — 5 A

Interior

Vanity lights (if equipped) 7065 1.4 C Personal/interior lights Front — 5 A Center — 5 A Rear — 5 A Interior light 7506 5 C Foot well lighting — 1.4 A Door courtesy lights 168 5 A


Download Manual