Mirrors
Inside Day/Night Mirror
A two-point pivot system allows for horizontal and vertical adjustment of the mirror. Adjust the mirror to center on the view through the rear window. The mirror should be adjusted while set in the day position (toward the windshield). Headlight glare can be reduced by moving the small control lever under the mirror to the night position (lever flipped toward the rear of vehicle).
The mirror should be adjusted with the lever set in the day position (lever flipped toward the windshield). The mirror should be adjusted to center on the view through the rear window.
Adjusting Rearview Mirror
Automatic Dimming Mirror If Equipped
This mirror automatically adjusts for headlight glare from vehicles behind you. You can turn the feature on or off by pressing the button at the base of the mirror. A light to the left of the button will illuminate to indicate when the dimming feature is activated. The sensor to the right of the button does not illuminate.
CAUTION! To avoid damage to the mirror during cleaning, never spray any cleaning solution directly onto the mirror. Apply the solution onto a clean cloth and wipe the mirror clean.
Automatic Dimming Mirror
Outside Mirrors
To receive maximum benefit, adjust the outside mirror(s) to center on the adjacent lane of traffic with a slight overlap of the view obtained on the inside mirror.
WARNING! Vehicles and other objects seen in a passenger side convex mirror will look smaller and farther away than they really are. Relying too much on your passenger side convex mirror could cause you to collide with another vehicle or other object. Use your inside mirror when judging the size or distance of a vehicle seen in the passenger side convex mirror. Some vehicles will not have a convex right side mirror.
Outside Mirrors Folding Feature
All exterior mirrors are designed to be able to be manu- ally folded both forward and rearward to prevent dam- age.
Folding Mirror
CAUTION! It is recommended to fold the mirrors into the full rearward position to resist damage when entering a car wash or a narrow location.
Power Mirrors If Equipped
The controls for the power mirrors are located on the driver’s door trim panel.
The power mirror controls consist of mirror select but- tons and a four-way mirror control switch.
Power Mirror Controls
To adjust a mirror, press the mirror select button for the mirror that you want to adjust. Using the mirror control switch, press on any of the four arrows for the direction that you want the mirror to move.
Power Mirror Controls
1 Mirror Select Buttons 2 Mirror Control
Power Mirror Movement
Power Folding Outside Mirrors If Equipped
If equipped with power folding mirrors, they can be electrically folded rearward and unfolded into the drive position. The power folding mirrors are designed to operate if the vehicle is stationary or traveling at speed of less than 35 mph (56 km/h). At speeds greater than 35 mph (56 km/h), the fold feature will be disabled, however the mirrors will attempt to unfold at any speed. If you attempt to unfold the mirrors at high speeds, they may not fully unfold - slow down and try again. The switch for the power folding mirrors is located between the power mirror switches L (left) and R (right). Press the switch once and the mirrors will fold in, pressing the switch a second time will return the mirrors to the normal driving position.
NOTE: Ten or more switch activations within one minute will disable the fold/unfold feature to protect the motors from overheating.
Power Folding Mirror Switch
Heated Mirrors If Equipped
These mirrors are heated to melt frost or ice. This feature is activated whenever you turn on the rear
window defroster. Refer to “Rear Window Features” in “Understanding the Features of Your Vehicle” for further information.
Driver’s Automatic Dimming Mirror If Equipped
The driver’s outside mirror will automatically adjust for glare from vehicles behind you. This feature is controlled by the inside automatic dimming mirror and can be turned on or off by pressing the button at the base of the inside mirror. The mirror will automatically adjust for headlight glare when the inside mirror adjusts.
Illuminated Vanity Mirror If Equipped
Illuminated vanity mirrors are located on each sun visor. To use the mirror, rotate the sun visor down and swing the mirror cover upward. The lights will turn on auto- matically. Closing the mirror cover turns off the light.
“Slide-On-Rod” Features Of Sun Visor If Equipped
The sun visor “Slide-On-Rod” feature allows for addi- tional flexibility in positioning the visor to block out the sun.
Illuminated Vanity Mirror
To use the “Slide-On-Rod” feature, rotate the sun visor downward and unclip it. Pull the sun visor along the “Slide-On-Rod” until the sun visor is in the desired position.
Trailer Towing Mirrors If Equipped
These mirrors are designed with an adjustable mirror head to provide a greater vision range when towing extra-wide loads. To change position inboard or out- board, the mirror head should be rotated (flipped in or out).
Slide-On-Rod Extender
Trailer Towing Position
NOTE: Fold the trailer towing mirrors rearward prior to entering an automated car wash. A small blindspot mirror is located next to main mirror and can be adjusted separately.
Download Manual