Door locks
Manual Door Locks
Front and rear doors may be locked by moving the lock knob down or unlocked by moving the lock knob up. Front doors may be opened with the inside door handle without lifting the lock knob. Doors locked before closing will remain locked when closed. The emergency key will unlock the driver door lock on your vehicle.
WARNING!
For personal security and safety in the event of an
accident, lock the vehicle doors when you drive as well as when you park and leave the vehicle.
Never leave children alone in a vehicle. Leaving unattended children in a vehicle is dangerous for a number of reasons. A child or others could be seriously or fatally injured. Don’t leave the key in the ignition. A child could operate power win- dows, other controls, or move the vehicle.
Power Door Locks If Equipped
A power door LOCK switch is on each front door trim panel. Use this switch to lock or unlock the doors.
If you press the power door LOCK switch while the Key Fob is in the ignition, and any front door is open, the
power locks will not operate. This prevents you from accidentally locking your Key Fob in the vehicle. Remov- ing the Key Fob or closing the door will allow the locks to operate. A chime will sound if the Key Fob is in the ignition switch and a door is open, as a reminder to remove the Key Fob.
Automatic Door Locks If Equipped
The doors will lock automatically if all of the following conditions are met: 1. The Automatic Door Locks feature is enabled 2. The transmission is in gear 3. All doors are closed 4. The throttle is pressed 5. The vehicle speed is above 15 mph (24 km/h)
Power Door Lock Switch Location
1 - Unlock 2 - Lock
6. The doors were not previously locked using the power door lock switch or Remote Keyless Entry (RKE) transmitter
Automatic Door Locks Programming If Equipped
The Automatic Door Locks feature can be enabled or disabled as follows: • For vehicles equipped with the Electronic Vehicle
Information Center (EVIC), refer to “Electronic Vehicle Information Center (EVIC) If Equipped/Personal Settings (Customer-Programmable Features)” in “Un- derstanding Your Instrument Panel” for further infor- mation.
For vehicles not equipped with the EVIC, perform the following procedure:
1. Close all doors and place the key in the ignition switch.
2. Within 15 seconds, cycle the ignition switch between LOCK and ON/RUN and then back to LOCK four times ending up in the LOCK position (do not start the engine). 3. Within 30 seconds, press the power door LOCK switch to lock the doors. 4. A single chime will indicate the completion of the programming. 5. Repeat these steps if you want to return this feature to its previous setting.
NOTE:
If you do not hear the chime it means that the system
did not enter the programming mode and you will need to repeat the procedure.
Use the Automatic Door Locks feature in accordance with local laws.
Auto Unlock Doors If Equipped
This feature unlocks all of the doors of the vehicle when either front door is opened. This will occur only after the vehicle has been shifted into the PARK position after the vehicle has been driven (shifted out of PARK and all doors closed).
Auto Unlock Doors Programming If Equipped
The Auto Unlock Doors feature can be enabled or dis- abled as follows: • For vehicles equipped with the EVIC, refer to “Elec-
tronic Vehicle Information Center (EVIC)/Personal Settings (System Setup)” in “Understanding Your In- strument Panel” for further information.
For vehicles not equipped with the EVIC, perform the following procedure:
1. Enter your vehicle and close all doors.
2. Fasten your seat belt. (Fastening the seat belt will cancel any chimes that may be confusing during this programming procedure.) 3. Insert the Key Fob into the ignition. 4. Within 15 seconds, cycle the Key Fob from the OFF position to the ON/RUN position a minimum of four times, ending in the OFF position.
(Do not start the engine). 5. Within 30 seconds, press the driver’s door UNLOCK switch. 6. A single chime will sound to indicate the feature has been changed. 7. Repeat the above steps to alternate the availability of this feature. 8. If a chime is not heard, the program mode was canceled before the feature could be changed. If neces- sary, repeat the above procedure.
Child-Protection Door Lock
To provide a safer environment for children riding in the rear seat, the rear doors (if equipped) of your vehicle have the Child-Protection Door Lock system.
To use the system, open each rear door, use a flat blade screwdriver (or emergency key) and rotate the dial to
engage and disengage the Child-Protection locks. When the system on a door is engaged, that door can only be opened by using the outside door handle even if the inside door lock is in the unlocked position.
Child-Protection Door Lock Location
Child Lock Control
WARNING! Avoid trapping anyone in a vehicle in a collision. Remember that the rear doors can only be opened from the outside when the Child-Protection locks are engaged.
NOTE:
After setting the Child-Protection Door Lock system,
always test the door from the inside to make certain it is in the desired position.
For emergency exit with the system engaged, move the door lock switch to the UNLOCK position, roll down the window and open the door with the outside door handle.
Download Manual