Initial Drive Information
This section provides a brief overview about some of the important features that may or may not be on your specific vehicle. For more detailed information, refer to each of the features which can be found later in this owner’s manual.
Remote Keyless Entry (RKE) System
The Remote Keyless Entry (RKE) transmitter may be used to lock and unlock the doors from up to 60 m (197 ft) away from the vehicle. Q : Press to lock all doors. K : Press to unlock the driver door or all doors, depending on the vehicle personalization settings. See “Remote Lock, Unlock, Start” under Vehicle Personalization 0 147. 7 : Press and release one time to initiate vehicle locator. Press and hold for three seconds to sound the panic alarm. Press again or start the vehicle to cancel the panic alarm.
X : Press twice quickly to release the trunk.
Press the key release button on the side of the transmitter to pull out the key. Never pull the key out without pressing the button. The key can be used for the driver door. See Keys 0 26 and Remote Keyless Entry (RKE) System Operation 0 27.
Remote Vehicle Start
The engine can be started from outside of the vehicle.
Starting the Vehicle
1. Press and release Q on the RKE
transmitter. 2. Immediately press and hold /
for at least four seconds or until the turn signal lamps flash.
Start the vehicle normally after entering. When the vehicle starts, the parking lamps will turn on. Remote start can be extended.
Canceling a Remote Start
To cancel a remote start, do one of the following: . Press and hold/ until the
parking lamps turn off. . Turn on the hazard warning
flashers. . Turn the vehicle on and then off. See Remote Vehicle Start 0 34.
IN BRIEF 9
Door Locks
To lock or unlock a door manually: . Use the key in the driver door. The key cylinder is covered by a cap. See Door Locks 0 35.
. To unlock a door from the inside, pull once on the door handle to unlock it, and again to open it.
Power Door Locks
. From the inside, press Q or K. See Power Door Locks 0 37.
. From the outside, press Q or K on the Remote Keyless Entry (RKE) transmitter, or press the button on the door handle when the RKE transmitter is within 1 m (3 ft). See Remote Keyless Entry (RKE) System Operation 0 27.
Trunk
To open the trunk: . Press| from inside the vehicle.
. PressX twice quickly on the Remote Keyless Entry (RKE) transmitter. See Remote Keyless Entry (RKE) System Operation 0 27.
. Press the emblem on the trunk after unlocking all doors. See Trunk 0 39.
Windows
The power windows work when the ignition is on, in ACC/ACCESSORY, or when Retained Accessory Power (RAP) is active. See Retained Accessory Power (RAP) 0 188.
10 IN BRIEF Using the window switch, press to open or pull to close the window. The windows may be temporarily disabled if they are used repeatedly within a short time. See Power Windows 0 46.
Seat Adjustment Uplevel Seat Adjustment
If equipped, the ignition must be on to use all uplevel seat features.
Uplevel Seat Control
1. Feature Select
2. Up 3. Rearward 4. Down 5. Forward
. Move Feature Select (1) to display seat adjustments on the infotainment display. Press and release or hold to scroll through features.
. Press Up (2) to make upward adjustments of the selected feature.
. Press Rearward (3) to make rearward adjustments of the selected feature.
. Press Down (4) to make downward adjustments of the selected feature.
. Press Forward (5) to make forward adjustments of the selected feature.
Base Seat Adjustment
To adjust the seat: . Move the seat forward or rearward
by sliding the control forward or rearward.
. Raise or lower the front part of the seat cushion by moving the front of the control up or down.
. Raise or lower the seat by moving the rear of the control up or down.
See Power Seat Adjustment 0 56.
Reclining Seatbacks
To adjust the seatback: . Tilt the top of the control
rearward to recline. . Tilt the top of the control forward
to raise. See Reclining Seatbacks 0 59.
Memory Features
Driver Buttons Shown, Passenger Buttons Similar
If equipped, memory seats allow two drivers to save and recall their unique seat positions for driving the vehicle, and a shared exit position for getting out of the vehicle. Other feature positions may also be saved, such as power mirrors and power steering wheel, if equipped. Memory positions are linked to RKE transmitter 1 or 2 for automatic memory recalls. Before saving, adjust all available memory feature positions. Turn the ignition on and then press and release
SET; a beep will sound. Then immediately press and hold 1, 2, orB (Exit) until two beeps sound. To manually recall these positions, press and hold 1, 2, orB until the saved position is reached. When Seat Entry Memory is enabled in vehicle personalization, positions previously saved to memory buttons 1 and 2 are recalled when the ignition is changed from off to on or ACC/ ACCESSORY. When Seat Exit Memory is enabled in vehicle personalization, the feature automatically recalls the previously saved exit position when exiting the vehicle. Memory adjustments may not be available upon delivery or after service until steps in “Saving Memory Positions” section are performed. See Memory Seats 0 60.
Second Row Seats
On some vehicles, either side of the seatback can be folded for more cargo space.
12 IN BRIEF See Rear Seats 0 65.
Heated and Ventilated Seats
If equipped, the buttons are near the climate controls on the center stack. To operate, the engine must be running. Press J or z to heat the driver or passenger seat cushion and seatback. PressC or { to ventilate the driver or passenger seat.
Press the button once for the highest setting. With each press of the button, the seat will change to the next lower setting, and then to the off setting. The indicator lights next to the buttons indicate three for the highest setting and one for the lowest. If the front heated seats are on high, the level may automatically be lowered after approximately 30 minutes. See Heated and Ventilated Front Seats 0 63.
Head Restraint Adjustment
Do not drive until the head restraints for all occupants are installed and adjusted properly. To achieve a comfortable seating position, change the seatback recline angle as little as necessary while keeping the seat and the head restraint height in the proper position. See Head Restraints 0 53 and Power Seat Adjustment 0 56.
Seat Belts
Refer to the following sections for important information on how to use seat belts properly: . Seat Belts 0 68 . How to Wear Seat Belts Properly
0 69 . Lap-Shoulder Belt 0 71 . Lower Anchors and Tethers for
Children (LATCH System) 0 95
Passenger Sensing System
United States
Canada
The passenger sensing system will turn off the front outboard passenger frontal airbag and knee airbag under certain conditions. No other airbag is affected by the passenger sensing system. See Passenger Sensing System 0 82. The passenger airbag status indicator lights on the overhead console when the vehicle is started. See Passenger Airbag Status Indicator 0 130.
Mirror Adjustment
Exterior Mirror
1. Move the selector switch to L (Left) or R (Right) to choose the driver or passenger mirror.
2. Press one of the four arrows to move the mirror.
3. Move the selector switch to ) to deselect the mirror.
The vehicle has manual folding mirrors or, if equipped, power folding mirrors. See Folding Mirrors 0 44.
Interior Mirror Adjustment
Hold the rearview mirror in the center and move it to view the area behind the vehicle.
Automatic Dimming Rearview Mirror
The vehicle has an automatic dimming rearview mirror. The mirror will automatically reduce the glare from the headlamps from behind. The dimming feature comes on when the vehicle is started. See Automatic Dimming Rearview Mirror 0 46.
Steering Wheel Adjustment
Press the control to move the tilt and telescoping steering wheel up and down or forward and rearward. Do not adjust the steering wheel while driving.
Interior Lighting
Dome Lamp
The dome lamp is in the overhead console.
To change the dome lamp settings, press:
OFF : Turns the lamp off, even when a door is open.
DOOR : The lamp comes on automatically when a door is opened.
ON : Turns the dome lamp on.
Reading Lamps
There are reading lamps on the overhead console and over the rear passenger doors. These lamps come on automatically when any door is opened. To manually turn the reading lamps on or off:
Press m or n next to each overhead console reading lamp.
Press the lamp lenses to turn the rear passenger reading lamps on or off.
IN BRIEF 15 For more information on interior lighting, see Instrument Panel Illumination Control 0 159.
Exterior Lighting
The exterior lamp control is on the turn signal lever. Turn the control to the following positions: O : Turns off the exterior lamps. The knob returns to the AUTO position after it is released. Turn to O again to reactivate the AUTO mode.
AUTO : Automatically turns the exterior lamps on and off, depending on outside lighting.
; : Turns on the parking lamps including all lamps, except the headlamps. 5 : Turns on the headlamps together with the parking lamps and instrument panel lights. See: . Exterior Lamp Controls 0 155 . Turn and Lane-Change Signals
0 158 . Headlamp High/Low-Beam Changer
0 156
Windshield Wiper/Washer
With the ignition on or in ACC/ ACCESSORY, move the lever to select the wiper speed.
HI : Use for fast wipes.
LO : Use for slow wipes.
INT : Use this setting for intermittent wipes or Rainsense, if equipped. For intermittent wipes, move the windshield wiper lever to INT. Turn thex INT band up for more frequent wipes or down for less frequent wipes. If equipped with Rainsense and the feature is enabled in vehicle personalization, move the windshield wiper lever to INT and turn thex INT band to adjust the sensitivity to moisture. . Turn the band up for more
sensitivity to moisture. . Turn the band down for less
sensitivity to moisture. . Move the windshield wiper lever
out of the INT position to deactivate Rainsense.
16 IN BRIEF To turn the Rainsense feature on or off, see “Rain Sense Wipers” under Vehicle Personalization 0 147.
OFF : Use to turn the wipers off.
1X : For a single wipe, briefly move the lever down. For several wipes, hold the lever down. nL : Pull the lever toward you to spray windshield washer fluid and activate the wipers. See Windshield Wiper/Washer 0 113.
Climate Controls
The climate control buttons and the climate control display are used to adjust the heating, cooling, and ventilation.
Climate Control Buttons
1. Driver and Passenger Temperature Controls
2. Fan Control
3. OFF (Fan)
4. Driver and Passenger Heated and Ventilated Seats (If Equipped)
5. Recirculation
6. Rear Window Defogger
7. Defrost
8. AUTO (Automatic Operation)
Climate Control Display
1. Climate Control Selection (Application Tray Button)
2. Driver and Passenger Temperature Controls
3. Fan Control
4. REAR (Rear Climate Control Display)
5. Sync (Synchronized Temperature)
6. Outside Temperature Display
7. Air Delivery Mode Control
8. A/C (Air Conditioning) See Dual Automatic Climate Control System 0 163 and Rear Climate Control System 0 168, if equipped.
Transmission
Tap Shift
Tap Shift allows the driver to manually control the automatic transmission. To use Tap Shift, the shift lever must be in M (Manual Mode). If equipped, the controls are on the back of the steering wheel. Tap the left control to downshift, and the right control to upshift. A Driver Information Center (DIC) message indicates the gear the vehicle is in. See Manual Mode 0 193.
Download Manual