Seats
Your vehicle’s seats can be adjusted either manually or electrically, depending on how your vehicle is equipped.
WARNING!
• Adjusting a seat while the vehicle is moving is
dangerous. The sudden movement of the seat could cause you to lose control. The seat belt might not be properly adjusted and you could be injured. Adjust the seat only while the vehicle is parked.
• Do not ride with the seatback reclined so that the shoulder belt is no longer resting against your chest. In a collision you could slide under the seat belt and be seriously or even fatally injured. Use the recliner only when the vehicle is parked.
NOTE: When moving the seat, be sure that there are no items in the footwell or behind the seats. Otherwise you could damage the seats.

Manual Seat Adjustments (If Equipped) Seat Height (Drivers Seat Only)
• Pull up on handle 3. • To lower the seat, use your body weight to push the
seat downward. • To raise the seat, lift your body weight off the seat to
obtain a higher seat position. • Release handle 3 when you are at your desired seat
level.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 89
3
Forward/Rearward
• Pull up on handle 4. • Move the seat forward or backward to your desired
position which allows you to reach the pedals com- fortably.
• Let go of handle 4. The seat should make an audible click when positioned properly.
• Check for proper engagement before driving.
Backrest Tilt
• Turn handwheel 2 forward or backward to adjust the
backrest tilt to your desired position which allows your arms to slightly bend when holding the steering wheel.
Head Restraint Height
WARNING! For your protection, drive only with properly posi- tioned head restraints. Adjust head restraint to support the back of the head approximately at ear level. Do not drive the vehicle without the seat head restraints. Head restraints are intended to help re- duce injuries during and accident.
• Adjust the height of the head restraints by pulling them upwards manually.
• For a lower position, press release button 1 and push down on the head restraints manually.
Adjust to a comfortable seating position that still allows you to reach the accelerator and brake pedal safely. The position should be as far to the rear as possible, consistent with ability to properly operate controls.
Driver Eight-Way Power Seat (If Equipped)
The switches to adjust the power seats are located on the outboard side of each seat.

The driver’s seat features eight-way power adjustment - horizontal, vertical, cushion tilt and back angle.

Passenger Four-Way Power Seat (If Equipped)
The switches to adjust the passenger seat are also on the outboard side of the seat. The passenger seat provides four-way adjustment - horizontal and back angle.

Heated Seats (If Equipped)
This feature heats the driver and passenger seats. The controls for the heated seats are located on the instrument panel, below the radio.

After turning the ignition switch ON, you can choose the HI, LO, or OFF setting. Indicators on the switches show which setting has been selected.
The heated seats setting will automatically switch from HI to LO after approximately five minutes.
TO OPEN AND CLOSE THE HOOD
To open the hood, pull the release lever located inside your vehicle, below the instrument panel.

Then, reach under the hood and pull upward on the safety latch and lift the hood. To prevent possible damage, close the hood by dropping it from approximately 12 in (30 cm).

WARNING! If the hood is not fully latched, it could fly up when the vehicle is moving, and block your forward vision. You could have a collision. Be sure all hood latches are fully latched before driving.
Download Manual