2022 Honda Accord Owners Manual - Driving Position Memory System*

Driving Position Memory System*

You can store two driver’s seat positions (except for power lumbar) with the driving position memory system.

When you unlock and open the driver’s door with a remote transmitter or keyless access system, the seat adjust automatically to one of the two preset positions.

When you enter the vehicle, the driver information interface briefly shows you which remote transmitter you used to unlock the vehicle.

• DRIVER 1 transmitter is linked to memory button 1.
• DRIVER 2 transmitter is linked to memory button 2.

The driver’s seat moves rearward depending on the set seating position once you

• Stop the vehicle.
• Put the transmission into (P).
• Turn the engine off.
• Open the driver’s door

Once the power mode is in the ACCESSORY position, the driver’s seat moves forward to the DRIVER 1 or 2 preset position.

Using the audio/information screen you can disable the automatic seat adjustment function.

The driver’s seat easy exit feature can be turned ON/ OFF.

System Operation
The system will not operate if:

• The vehicle speed is above 2 mph (3 km/h).
• Either memory position button is pressed while the seat is in motion.
• The seat position is adjusted while in operation.
• The memory 1 or 2 position is set fully to the rear.

The system may not recognize a key if:

• The key is in close proximity to a cell phone or other wireless device.
• Both keys are in the vehicle at the same time.
• The Driving Position Memory System is disabled in customized features.
• Opening driver's door without fully grabbing door handle.

Storing a Position in Memory

1. Set the power mode to ON. Adjust the driver’s seat to the desired position.
2. Press the SET button.
   You will hear the beeper, and the memory button indicator light will blink.
3. Press the memory button (1 or (2 within five seconds of pressing the SET button.
   Once the seat position has been memorized, the indicator light on the button you pressed stays on and you will hear two beeps.

After you press the SET button, the storing operation will be canceled when:

• You do not press the memory button within five seconds.
• You readjust the seat position before the two beeps.
• You set the power mode to any position except ON.

Recalling the Stored Position

• Put the transmission into (P).
• Apply the parking brake.
• Press a memory button ((1) or (2).
  You will hear a beep, and the indicator light will blink.

The seat will automatically move to the memorized position. When it has finished moving, you will hear a beep, and the indicator light stays on.

The seat will stop moving if you:

• Press the SET button or memory button ((1) or (2)).
• Adjust the seat position.