DOOR LOCKS
Manual Door Locks
All the doors can be manually locked from the inside by pushing down the door lock knob, located on the door trim panel. Both front doors may be opened from the inside with the door lock knob in the down or locked position.
Manual Door Lock Knob
WARNING!
• For personal security and safety in the event of an
accident, lock the vehicle doors as you drive, as well as when you park and leave the vehicle.
• Never leave children alone in a vehicle. Leaving unattended children in a vehicle is dangerous for a number of reasons. A child or others could be seriously or fatally injured. Don’t leave the key in the ignition. A child could operate power win- dows, other controls, or move the vehicle.
Power Door Locks
A power door lock switch is on each front door trim panel. Use this switch to lock or unlock the doors.
If you press the power door LOCK switch while the key is in the ignition, and any front door is open, the power locks will not operate. This prevents you from accidentally locking your keys in the vehicle. Removing the key, or closing the door, will allow the locks to operate. A chime will sound if the key is in the ignition switch and the driver’s door is open, as a reminder to remove the key.
Power Door Lock Switch
Automatic Door Locks — If Equipped
The doors will lock automatically if all of the following conditions are met: 1. The Automatic Door Locks feature is enabled 2. The transmission is in gear 3. All doors are closed 4. The throttle is pressed 5. The vehicle speed is above 15 mph (24 km/h) 6. The doors were not previously locked using the power door lock switch or Remote Keyless Entry (RKE) transmitter
Automatic Door Locks Programming — If Equipped
The Automatic Door Locks feature can be enabled or disabled as follows:
• For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to “Electronic Vehicle Information Center (EVIC) — If Equipped/Personal Settings (Customer-Programmable Features)” in “Un- derstanding Your Instrument Panel” for further infor- mation.
• For vehicles not equipped with the EVIC, perform the following procedure:
1. Close all doors and place the key in the ignition switch. 2. Within 15 seconds, cycle the ignition switch between LOCK and ON/RUN and then back to LOCK four times ending up in the LOCK position (do not start the engine). 3. Within 30 seconds, press the power door LOCK switch to lock the doors. 4. A single chime will indicate the completion of the programming.
5. Repeat these steps if you want to return this feature to its previous setting.
NOTE:
• If you do not hear the chime it means that the system
did not enter the programming mode and you will need to repeat the procedure.
• Use the Automatic Door Locks feature in accordance with local laws.
Auto Unlock On Exit Feature — If Equipped
This feature unlocks all of the doors of the vehicle when any door is opened. This will occur only after the vehicle has been shifted into the PARK position after the vehicle has been driven (shifted out of PARK and the doors closed).
Auto Unlock Feature Programming
The Customer Programming sequence to disable or en- able Auto Unlock:
1. Enter your vehicle and close all the doors. 2. Fasten your seat belt. (Fastening the seat belt will cancel any chiming that may be confusing during this programming procedure.) 3. Insert the key into the ignition. 4. Within 15 seconds, cycle the key from the LOCK position to the ON/RUN position and back to LOCK position, a minimum of four times; ending in the LOCK position. (Do not start the engine.)
5. Within 30 seconds, press the driver’s door LOCK switch in the UNLOCK direction. 6. A single chime will sound to indicate the feature has been changed. 7. To reactivate the feature, repeat the above steps. 8. If a chime is not heard, program mode was canceled before the feature could be changed. If necessary, repeat the above procedure.
Child-Protection Door Lock
To provide a safer environment for children riding in the rear seat, the rear doors of your vehicle have the child- protection door lock system.
To use the system, open each rear door, slide the lever up to engage the locks, and down to disengage the child- protection locks. When the system on a door is engaged, that door can only be opened by using the outside door handle, even if the inside door lock is in the unlocked position.
Child-Protection Door Lock Location
Child Lock Control
WARNING! Avoid trapping anyone in a vehicle in a collision. Remember that the rear doors can only be opened from the outside when the Child-Protection locks are engaged.
NOTE:
• After setting the Child-Protection Door Lock system,
always test the door from the inside to make certain it is in the desired position.
• For emergency exit with the system engaged, move the door lock switch to the UNLOCK position, roll down the window and open the door with the outside door handle.
Download Manual