Lighting Features
Some exterior lamps and interior lamps turn on briefly at night, or in areas with limited lighting, when K is pressed on the Remote Keyless Entry (RKE) transmitter. After about 30 seconds the exterior lamps turn off.
Entry lighting can be disabled manually by turning the ignition on or to ACC/ ACCESSORY, or by pressing Q on the RKE transmitter. When any door is opened or remote unlock pressed, all interior lights
turn on and then interior lamps dim to off after 20 seconds.
The entry lighting feature for exterior lighting can be changed. See “Vehicle Locator Lights” under Vehicle Personalization 0 104.
Some exterior lamps come on at night or in areas with limited lighting when the driver door is opened after the ignition is
turned off.
The interior lamps come on after the ignition is turned off or any door is opened.
The exterior and interior lamps remain on after the door is closed for a set amount of time then automatically turn off.
Exit lighting for exterior lights can be changed. See Vehicle Personalization 0 104.
This feature allows for a three to five second fade out of the interior lamps instead of having them turn off immediately.
The vehicle has Electric Power Management (EPM) that estimates the battery's temperature and state of charge. It then adjusts the voltage for best performance and extended life of the battery.
When the battery's state of charge is low, the voltage is raised slightly to quickly bring the charge back up. When the state of charge is high, the voltage is lowered slightly to prevent overcharging. If the vehicle has a voltmeter gauge or a voltage display on the Driver Information Center (DIC), you may see the voltage move up or down. This is normal. If there is a problem, an alert will be displayed.
The battery can be discharged at idle if the electrical loads are very high. This is true for all vehicles. This is because the generator (alternator) may not be spinning fast enough at idle to produce all of the power needed for very high electrical loads.
A high electrical load occurs when several of the following are on, such as: headlamps, high beams, rear window defogger, climate control fan at high speed, heated seats, engine cooling fans, trailer loads, and loads plugged into accessory power outlets.
EPM works to prevent excessive discharge of the battery. It does this by balancing the generator's output and the vehicle's electrical needs. It can increase engine idle speed to generate more power whenever needed. It can temporarily reduce the power demands of some accessories.
Normally, these actions occur in steps or levels, without being noticeable. In rare cases at the highest levels of corrective action, this action may be noticeable to the driver. If so, a DIC message might be displayed and it is recommended that the driver reduce the electrical loads as much as possible.
This feature shuts off the interior lamps if they are left on for more than 10 minutes when the ignition is off. This helps to prevent the battery from running down.
The exterior lamps turn off about 10 minutes after the ignition is turned off, if the parking lamps or headlamps have been manually left on. This protects against draining the battery. To restart the 10-minute timer, turn the exterior lamp control to the off position and then back to the parking lamp or headlamp position.
To keep the lamps on for more than 10 minutes, the ignition must be on or in ACC/ACCESSORY.
Download Manual