Turn signals
Switching the turn signals on and off
Fig. 95 On the left side of the steering column: turn signal and high beam lever.
Right turn signal 
.
Left turn signal 
.
Switching the turn signals on and off
-
Switch the ignition on.
-
Move the turn signal and high beam lever from the center position to the preferred position fig. 95.
-
To cancel the turn signal, move the turn signal and headlamp lever back to its basic position.
If no chime sounds when the turn signal is on, contact suitably qualified professionals and have the vehicle checked. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.
3-blink turn signal
To use the 3-blink turn signal, move the turn signal and high beam lever upward or downward to the pressure point and then release the lever. The turn signal will blink three times.
To stop the 3-blink turn signal before it ends, move the turn signal and high beam lever immediately to the pressure point in the opposite direction and release.
The 3-blink turn signal can be activated and deactivated in the vehicle settings in the Infotainment system
WARNING
Using the turn signals incorrectly, not using the turn signals, or forgetting to turn the turn signal off can mislead other road users. This can cause accidents and serious injuries.
-
Always activate the turn signals correctly when changing lanes, passing, or turning.
-
Switch the turn signal off again every time you finish changing lanes, passing, or turning.
The emergency flashers also work when the ignition is switched off
Download Manual