Check engine is on light. no power when you apply the gas pedal. this is the 3rd time the car is at the dealership for the same problem. previously dealership scanned for codes. codes that where present indicated turbo boot control/position sensor and adjusted ewga rod.b. *kb
Dealer claims they referred to previous service history. check engine light was on. when depress gas pedal car does not responded. this is the same problem i had on july 13, 2011. dealer scanned for codes. did not state in work order which codes where present. called kia tech line. adjust turbo, inspect and adjust ewga rod on turbo. road tested. cleared codes and road tested again ok. car was out of commission from august 1, 2011 at roughly 8:00 am until august 4 2011 at 3:30 pm when dealer called and said car was ready for pickup. consumer e-mailed invoice and tsb. 08/08/11
Engine light is on and no power when you apply gas pedal. dealer pulled codes for ob2 and found p2562 turbo boot control/position sensor. rest both adpat values. after resting and rebooting ecm drivers windows would not go up. asked dealer if car was safe to driver. dealer stated yes and said the only problem was the window. after pulling out on to a major busy 6 lane highway i discover i had no turns signals. pulled car off the road and checked to is what other lights where not working. i discovered i had no day time running lights, headlights, fog lights and power door locks did not work. dealer states bad bcm and replaced it.