Bulb Replacement
Headlamp
NOTE: Lens fogging can occur under certain atmospheric conditions. This will usually clear as atmospheric conditions change to allow the condensation to change back into a vapor. Turning the lamps on will usually accelerate the clearing process.
- Raise the hood and locate the connector behind the headlamp.
- Reach into engine compartment and pull red lock out at connector.
- Remove the green connector from the back of the bulb by pulling straight back.
- Twist the bulb to the left.
- Pull bulb outward from assembly
NOTE: These are halogen bulbs. Take care not to touch the bulb with your fingers. Body oils from your fingers could cause excessive heat buildup which reduces bulb life.
Fog Lamps
- Access lamp through the lower fascia cutout.
- Remove electrical connector from bulb.
- Remove bulb from housing.
CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.
Rear Tail, Turn Signal And Backup Lamps
- Raise the liftgate.
- Remove the two push-pins from the taillamp housing.
- Grasp the taillamp and pull firmly to disengage the light from the aperture panel.
- Twist and remove socket from the light.
- Remove bulb from socket and replace.
License Lamps
- Use a screw driver to gently pry against the side of the snap tab to remove the lamp from the liftgate.
- Rotate the socket 1/4 turn counterclockwise.
- Pull the bulb from the socket.
Center High-Mounted Stoplamp
This light is an LED assembly. See your authorized dealer for replacement.