2022 Infiniti QX60 Owners Manual - Headlight and turn signal swith

Headlight and turn signal swith

HEADLIGHT CONTROL SWITCH

Lighting

1. Rotate the switch to the position, and the front parking, tail, license plate, and instrument panel lights will come on.
2. Rotate the switch to the position, and the headlights will come on and all the other lights remain on.

CAUTION

Use the headlights with the engine run-ning to avoid discharging the vehicle battery.

Autolight system

The autolight system allows the headlights to turn on and off automatically. The auto-light system can:

• Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark.
• Turn off all the lights (except Daytime Running Lights) when it is light.
• Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.

NOTE:

Autolight activation sensitivity (if so equipped) and the time delay for auto-light shutoff can be adjusted. For addi-tional information, see “Vehicle infor-mation display-7 inch (18 cm) Type A” (P. 2-22) or “Vehicle information display-12.3 inch (31 cm) Type B” .

To turn on the autolight system:

1. Turn the headlight switch to the AUTO position O1 .
2. Place the ignition switch in the ON position.
3. The autolight system automatically turns the headlights on and off.

Initially, if the ignition switch is placed in the OFF position and a door is opened and left open, the headlights remain on for a period of time. If another door is opened while the headlights are on, then the timer is reset.

To turn the autolight system off, turn the switch to the OFF, , or position.

Be sure you do not put anything on top of the autolight sensor located in the top side O1 of the instrument panel. The auto-light sensor controls the autolight; if it is covered, the autolight sensor reacts as if it is dark out and the headlights will illumi-nate. If this occurs while parked with the engine off and the ignition switch placed in the ON position, your vehicle's battery could become discharged.

Headlight beam select

1. To select the high beam function, push the lever forward. The high beam lights come on and the light illuminates.
2. Pull the lever back to select the low beam.
3. Pulling and releasing the lever flashes the headlight high beams on and off.