Headlamp aiming (For Europe)
Headlamp aiming
- . Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools.
- The vehicle should be placed on a flat floor.
- Draw vertical lines (Vertical lines passing through respective head lamp centers) and a horizontal line (Horizontal line passing through center of head lamps) on the screen.
- With the headlamp and battery in normal condition, aim the headlamps so the brightest portion falls on the horizontal and vertical lines.
- To aim the low beam left or right, turn the driver clockwise or counterclockwise. To aim the low beam up or down, turn the driver clockwise or counterclockwise. To aim the high beam up or down, turn the driver clockwise or counterclockwise.
Aiming point
■ Type A
| Vehicle condition | H1 | H2 | W1 | W2 |
| Without driver | 738.6 (29.08) |
712.8 (28.06) |
1,465 (57.67) |
1,238 (48.74) |
| With driver | 731.6 (28.80) |
705.8 (27.78) |
1,465 (57.67) |
1,238 (48.74) |
■ Type B
| Vehicle condition | H1 | H2 | W1 | W2 |
| Without driver | 724.6 (28.52) |
706.2 (27.80) |
1400.8 (55.14) |
1175.2 (46.26) |
| With driver | 717.6 (28.25) |
699.2 (27.53) |
Headlamp low beam (LHD side)
- Turn the low beam on without driver aboard.
- The cut-off line should be projected in the cut-off line shown in the picture.
- When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming.
- If headlamp leveling device is equipped, adjust the head lamp leveling device switch to “0”.
Headlamp low beam (RHD side)
Download Manual