Light Bulbs
WARNING - Working on the lights
Prior to working on the light, firmly apply the parking brake, ensure that the ignition switch is turned to the LOCK position and turn off the lights to avoid sudden movement of the vehicle and burning your fingers or receiving an electric shock.
Use only the bulbs of the specified wattage.
CAUTION
Be sure to replace the burned-out bulb with one of the same wattage rating. Otherwise, it may cause damage to the fuse or electric wiring system.
CAUTION
If you don’t have necessary tools, the correct bulbs and the expertise, consult an authorized HYUNDAI dealer. In many cases, it is difficult to replace vehicle light bulbs because other parts of the vehicle must be removed before you can get to the bulb. This is especially true if you have to remove the headlight assembly to get to the bulb(s). Removing/installing the headlight assembly can result in damage to the vehicle.
✽ NOTICE
After driving in rain or washing, the headlight and taillight lenses could appear frosty. This condition is caused by the temperature difference between the lamp inside and outside. This is similar to the condensation on your windows inside your vehicle during the rain and doesn’t indicate a problem with your vehicle. If the water leaks into the lamp bulb circuitry, have the vehicle checked by an authorized HYUNDAI dealer.
Headlight, position light, turn signal light, side marker light and front fog light bulb replacement
(1) Headlight (High)
(2) Headlight (Low)
(3) Front side marker light
(4) Front turn signal light
(5) Position light
(6) Front fog light (if equipped)
Headlight bulb
WARNING - Halogen bulbs
- Halogen bulbs contain pressurized gas that will produce small pieces of glass if broken.
- Always handle the bulbs carefully, and avoid scratches and abrasions. If the bulbs are lit, avoid contact with liquids.
- Never touch the glass with bare hands. Residual oil may cause the bulb to overheat and burst when lit.
- If a bulb becomes damaged or cracked, replace it immediately and carefully dispose of it.
- Wear eye protection when changing a bulb. Allow the bulb to cool down before handling it.
Headlight (HID type) bulb replacement (if equipped)
If the light bulb is not operating, have the vehicle checked by an authorized HYUNDAI dealer.
WARNING - HID Headlight low beam (if equipped)
Do not attempt to replace or inspect the low beam (XENON bulb) due to electric shock danger. If the low beam (XENON bulb) is not working, have your vehicle checked by an authorized HYUNDAI Dealer.
CAUTION
If your vehicle is equipped with High Intensity Discharge (HID) headlights, these headlights contain mercury. So if you need to have your vehicle disposed, you should remove the HID Headlights before disposal. The removed HID headlights should be recycled, re-used or disposed as hazardous waste.
NOTICE
HID lamps have superior performance vs. halogen bulbs. HID lamps are estimated by the manufacturer to last twice as long or longer than halogen bulbs depending on their frequency of use. They will probably require replacement at some point in the life of the vehicle. Cycling the headlamps on and off more than typical use will shorten HID lamp life. HID lamps do not fail in the same manner as halogen incandescent lamps. If a headlamp goes out after a period of operation but will immediately relight when the headlamp switch is cycled it is likely the HID lamp needs to be replaced. HID lighting components are more complex than conventional halogen bulb and thus have higher replacement cost.
Headlight (bulb type), front turn signal, position, side marker and fog light bulbs (if equipped)
If the light bulb is not operating, have the vehicle checked by an authorized HYUNDAI dealer.
✽ NOTICE
Always have the headlight aiming adjusted after an accident or the headlight assembly is reinstalled at an authorized HYUNDAI dealer.
Side repeater light bulb replacement (if equipped)
If the light bulb is not operating, have the vehicle checked by an authorized HYUNDAI dealer.
Rear combination light bulb replacement
(1) Back-up light
(2) Rear turn signal light
(3) Stop and tail light
(4) Rear side marker light
(5) Tail light
Rear turn signal light
- Open the trunk lid.
- Remove the service cover by pulling out the service cover.
- Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
- Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.
- Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
- Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
- Install the service cover by putting it into the service hole.
Back-up, stop and tail light
If the light is not operating, have the vehicle checked by an authorized HYUNDAI dealer.
High mounted stop light
1. Remove the rear seat
1.Disconnect the negative battery cable.
2.Remove the rear seat cushion.
3.Loosen the mounting bolts, then remove the rear seat back.
4.Disconnect the connector.
5.Push the hook, disconnect the main connector.
6.Loosen the mounting bolts, then disconnect the connector.
7.Remove the side seat.
2. Remove the rear package tray trim
1.Remove the rear door scuff trim.
2.Loosen the mounting screw, then remove the rear wheel house trim.
3.Remove the cap, then loosen the mounting screw.
4.Remove the rear pillar trim.
5.Push the hook, remove the rear seat belt cover.
6.Remove the rear seat belt lower anchor.
7.Loosen the mounting screws, then remove the package tray trim.
3. Replace the high mounted stop light
1.Remove the high mounted stop lamp after removing screws.
2.Install a new light.
4. Installation
Installation is the reverse of removal.
License plate light bulb replacement
1. Loosen the lens retaining screws with a philips head screwdriver.
2. Remove the lens.
3. Remove the bulb by pulling it straight out.
4. Install a new bulb.
5. Reinstall the lens securely with the lens retaining screws.
Door courtesy lamp bulb replacement
If the light is not operating, have the vehicle checked by an authorized HYUNDAI dealer.
Interior light bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens from the interior light housing.
2. Remove the bulb by pulling it straight out.
WARNING
Prior to working on the Interior Lights, ensure that the “OFF” button is depressed to avoid burning your fingers or receiving an electric shock.
3. Install a new bulb in the socket.
4. Align the lens tabs with the interior light housing notches and snap the lens into place.
5. If the map lamp and room lamp are not operating, have the vehicle checked by an authorized HYUNDAI dealer.
CAUTION
Use care not to dirty or damage lens, lens tab, and plastic housings.