Headlamp, Position Lamp, Turn Signal Lamp and Daytime Running Light Bulb Replacement
(1) Headlamp (Low)
(2) Headlamp (High)
(3) Daytime running lamp (DRL)/Parking lamp
(4) Turn signal lamp
(5) Side marker
Turn signal lamp
1. Open the hood.
2. Disconnect the negative battery cable.
3. Remove the socket from the assembly by turning the socketcounterclockwise until the tabs on the socket align with the slots onthe assembly.
4. Remove the bulb from the socket by pressing it in and rotating itcounterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
6. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly.
7. Push the socket into the assembly and turn the socket clockwise.
Lamps
If the LED lamp does not operate, have the vehicle checked by an authorized HYUNDAI dealer.
Side Repeater Lamp
Replacement
If the LED lamp (1) does not operate, have the vehicle checked by an authorized HYUNDAI dealer.
Rear Combination Lamp Bulb
Replacement
(1) Stop lamp (LED)
(2) Tail lamp (LED )
(3) Turn signal lamp
(4) Reverse lamp
(5) Side marker (LED)
Tail/Stop lamp
If the tail/stop lamp do not operate, have the vehicle checked by an authorized HYUNDAI dealer.
Turn signal lamp (Outer lamp) (Bulb type)
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Loosen the assembly retaining nuts.
4. Remove the rear combination light assembly from the body of the vehicle.
[1] : Turn signal lamp
5. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
6. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.
7. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
8. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
Reverse lamp (Inner lamp) (Bulb type)
1. Disconnect the connector and then remove the nuts by turning the nuts counter clockwise.
2. Take the light assembly out.
3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
4. Remove the bulb by pulling it out.
5. Insert a new bulb by inserting it into the socket.
6. Install the light assembly to the trunk.
7. Reinstall the trunk lid cover by pushing in the screw.
Fog lamp (if equipped)
If the lamp does not operate, have the vehicle checked by an authorized HYUNDAI dealer.
Download Manual