I was driving on the highway and the main screen in the center of the dashboard turned off and had the message 'turning off system to save battery'. this was not an accurate projection by the car system being that i just recently installed a brand new battery a couple of days prior. as the car system continued to shut down, the alert of 'system charging service now' showed up on the dash. following that message the power steering completely shut down. shortly there after, the entire electrical system shut down in my car. lights, steering, dashboard, electronic seats, doors, gear shift, everything! this all happened in the span of 1 minute or so on a highway at 11pm at night. i almost got into an inescapable acccident trying to find somewhere to get the car off the highway. shortly there after the engine also cut off due to not getting any power from the car system. this is very unfortunate because this car is only 2 years old and i bought the car brand new off the lot.
This vehicle has had a dead battery 3 times after sitting overnight. no extra power draws we added. the last resulted with the engine light on once it was jump started. the engine code that was on was a p068a ecm/pcm power relay de-energized performance - too early. this vehicle has already been brought into the dealership where they performed a battery test and reprogrammed the modules. this was less than 1 month till it happened again
This vehicle has had a dead battery 2 times after sitting overnight. no extra power draws we added. the last resulted with the engine light on once it was jump started. the engine code that was on was a p068a ecm/pcm power relay de-energized performance. it will be scheduled to go to the dealership to try to resolve this issue
Auto headlights delay setting in ford fusion. i took a rental car and ensured the lights were set to automatic. there is a hidden feature in ford fusion where we can set a delay for the lights to turn on. i entered a tunnel which is completely dark and no lights were there inside the tunnel. i could not see anything as the lights didn't turned on. i fortunately met with a small incident but this hidden feature doesn't make any sense. i drove other vehicles where in automatic lights switch on immediately. i am unaware of this setting as i don't own this car. please ensure manufacturer disables this setting and they ensure safety of ford users. the rental company declined to accept it as their fault but i want someone like nhtsa contact rental car companies to disable these settings and also contact the manufacturer and understand the benefit of this setting. as per me it is a risky setting without much positive benefits. i want to ensure safety of other ford users.
I have noted, when passing newer ford fusions during non-daylight hours, that the headlights project brightly out of the side of the lens and slightly backward, to the point of being distracting and causing me to wince. i have not noted this to occur when passing any other vehicles but have noticed it when passing several newer ford fusions. it appears that the light emission pattern for the headlight assemblies is the contributing factor.
Spent several hundred $ s' having hid headlamps installed which helped, cannot drive after dark, because i can't see the side of the road at all when turning in either direction, have almost been hit twice, i have a safe driver, license and do not want to be in an accident, this vehicle is useless if i cannot drive at night when needed, i see this vehicle is also listed as having bad lighting on your website, f or motor co should have a recall to replace the substandard headlamps on this vehicle, worst i have ever encountered in my life !
The insurance institute for highway safety has rated "marginal" the headlight effectiveness for the 2016 ford fusion. i think ford should replace the headlights which is a safety issue and an expensive proposition.
This was a rental od 11433 miles. driving at night i activated the right turn signal and the right head lamp bulb went out. i repeated this signal left and the left head lamp bulb went out. when signaling was complete the head lamp came back on. i could not latch the high beam by the turn signal lever. it had to be manually held. these same repeated actions were done with the same results. on an until area a person at a corner may not have been visible? night two of driving the rental all worked and functioned properly as designed. all turn signal / head lamp bulb in addition to engaging and dis engaging high beams.