Replacement Bulbs
Interior Bulb
| Bulb Number | |
| Dome Lamp | W5W |
| Overhead Console Lamp | W5W |
| Low Beam/High Beam (Bi-Halogen Headlamp) | 9005HL+ |
| Low Beam/High Beam (Bi-Xenon Headlamp) | D3S ** |
| Front Park/Turn Signal Lamp | 7442NALL |
| Sidemarker Lamp | 194 |
| Front Fog Lamp | H11 |
| Center High-Mounted Stop Lamp (CHMSL) | LED (Serviced at Authorized Dealer) * |
| Rear Tail/Stop/Turn Signal Lamp | LED (Serviced at Authorized Dealer) * |
| Backup Lamp | 7440 |
| License Lamp | 168 |
* Lamp is not serviceable. It is a LED lamp. To replace the LED, the entire assembly must be replaced.
** The headlamps are a type of high-voltage discharge tube. High voltage can remain in the circuit even with the headlamp switch off and the key removed. Because of this, you should not attempt to service a headlamp bulb yourself. If a headlamp bulb fails, take your vehicle to an authorized dealer for service.
NOTE: Lens fogging can occur under certain atmospheric conditions. This will usually clear as atmospheric conditions change to allow the condensation to change back into a vapor. Turning the lamps on will usually accelerate the clearing process.
Headlamps
Halogen Headlamps
Can be serviced by removing the cap from the backside of the headlamp. Remove the HIR2 bulb from the connector and replacing the bulb. Reinstall bulb and cap.
High Intensity Discharge Headlamps (HID)
The headlamps are a type of high voltage discharge tube. High voltage can remain in the circuit even with the headlamp switch off and the key removed. Because of this, you should not attempt to service a headlamp bulb yourself. If a headlamp bulb fails, take your vehicle to an authorized dealer for service.
WARNING!
A transient high voltage occurs at the bulb sockets of HID headlamps when the headlamp switch is turned ON. It may cause serious electrical shock or electrocution if not serviced properly. See your authorized dealer for service.
Backup Lamps
1. Open trunk.
2. Remove trim cover.
Trim Cover
3. Twist the bulb socket one quarter turn counter clockwise to remove.
Bulb Socket
4. Replace bulb.
Backup Bulb
5. Twist the bulb socket one quarter turn clockwise to install.
6. Install trim cover.
License Lamp
1. Remove the screws securing the lamp to the rear fascia.
2. Remove the bulb and socket assembly.
3. Disconnect the bulb from the socket assembly and install the replacement bulb.
- License Lamp Bulb
- Socket
4. Reinstall the bulb and socket assembly
5. Reattach the lamp to the rear fascia, and then install the screws.