Exterior Lighting
Exterior Lamp Controls
The exterior lamp control is on the instrument panel to the left of the steering column.
There are four positions.
O : Turns the exterior lamps off and deactivates the AUTO mode. Turn O again to reactivate the AUTO mode.
In Canada, the headlamps will automatically reactivate when the vehicle is shifted out of P (Park).
AUTO : Turns the exterior lamps on and off automatically depending on outside lighting.
=|= : Turns on the parking lamps including all lamps, except the headlamps.
: Turns on the headlamps together with the parking lamps and instrument panel lights.
Exterior Lamps Off Reminder
A warning chime sounds if the driver door is opened while the ignition is off and the exterior lamps are on.
Headlamp High/ Low-Beam Changer
Push the turn signal lever away from you and release to turn the high beams on. To return to low beams, push the lever again or pull it toward you and release.
This indicator light turns on in the instrument cluster when the high-beam headlamps are on.
Flash-to-Pass
To flash the high beams, pull the turn signal lever toward you, and release.
Daytime Running Lamps (DRL)
DRL can make it easier for others to see the front of your vehicle during the day. Fully functional DRL are required on all vehicles first sold in Canada.
The dedicated DRL will come on when all of the following conditions are met:
- The ignition is on.
- The exterior lamp control is in AUTO.
- The light sensor determines it is daytime.
- The parking brake is released or the vehicle is not in P (Park).
When the DRL are on, the taillamps, sidemarker lamps, instrument panel lights, and other lamps will not be on.
The DRL turn off when the headlamps are turned to O or the ignition is off. For vehicles first sold in Canada, the DRL can only be turned off when the vehicle is parked.
This vehicle may have a DRL disabling function. When the DRL are on and a turn signal is activated, the DRL on that side will be off until the turn signal goes off.
Automatic Headlamp System
When the exterior lamp control is set to AUTO and it is dark enough outside, the headlamps come on automatically.
There is a light sensor on top of the instrument panel. Do not cover the sensor; otherwise the headlamps will come on when they are not needed.
The system may also turn on the headlamps when driving through a parking garage or tunnel.
If the vehicle is started in a dark garage, the automatic headlamp system comes on immediately. If it is light outside when the vehicle leaves the garage, there is a slight delay before the automatic headlamp system changes to the Daytime Running Lamps (DRL). During that delay, the instrument cluster may not be as bright as usual. Make sure the instrument panel brightness control is in the full bright position.
When it is bright enough outside, the headlamps will turn off or may change to Daytime Running Lamps (DRL).
The automatic headlamp system turns off when the exterior lamp control is turned to O or the ignition is off.
Adaptive Forward Lighting (AFL)
If equipped, the AFL pivots the headlamps horizontally to provide greater road illumination while turning. To enable AFL, set the exterior lamp control to the AUTO position. Moving the switch out of the AUTO position deactivates the system. AFL operates when the vehicle speed is greater than 3 km/h (2 mph). AFL does not operate when the transmission is in R (Reverse). AFL is not immediately operable after starting the vehicle; driving a short distance is required to calibrate the AFL.
Hazard Warning Flashers
A : : Press to make the front and rear turn signal lamps flash on and off. Press again to turn the flashers off.
The hazard warning flashers turn on automatically if the airbags deploy
Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn.
An arrow on the instrument cluster will flash in the direction of the turn or lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is complete. If the lever is moved momentarily to the lane change position, the arrow will flash three times. It will flash six times if Tow/Haul Mode is active.
The turn and lane-change signal can be turned off manually by moving the lever back to its original position.
If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb might be burned out.
Have any burned out bulbs replaced. If the bulb is not burned out, check the fuse.
Fog Lamps
The fog lamps button is on the instrument panel to left of the steering wheel.
To turn on the fog lamps, the ignition and the headlamps or parking lamps must be on.
If the fog lamps are turned on while the exterior lamp control is in the AUTO position, the headlamps come on automatically.
Press to turn on or off. An indicator light on the instrument cluster comes on when the fog lamps are on.
Download Manual