Tl* the contact owns a 2005 subaru outback. the contact stated that the vehicle was repaired per nhtsa campaign number: 14v311000 (service brakes, hydraulic); however, the remedy failed. when the brake pedal was depressed, the brake light fractured and brake fluid was leaking. the vehicle was towed to an independent mechanic who stated that the brake line was corroded. the vehicle was not repaired. the vehicle was towed to byers dublin subaru (2455 billingsley rd, columbus, oh 43235, (614) 792-2455), but no assistance was provided. the contact had been calling the dealer, but was not getting a response. the manufacturer was made aware of the failure and informed the contact that the vehicle was inspected by an independent contractor. all brake lines were replaced. the failure mileage was 255,081.*cw*jb
My outback developed a brake line leak. the leak was located is the same location that was inspected and rust proofed per nhtsa campaign: 14v-311000, service campaign wqk47. the leak was discover after my 16 son lost most of brakes while in motion. luckily there was not a serious crash as a result of the brake pedal going all the way to the floor board. the brake lines were repaired for $336. this recall was ineffective and the brake lines should have been better protected against corrosion.
The vehicle has soft brakes, it is common among this generation. it does not matter if everything is replaced. there is still a long/soft pedal travel. this may be due to an inadequate master cylinder size or brake booster size. this is a constant issue, does not matter when you use the brakes, it always is slow to stop and can be a bit scary.
Tl* the contact owns a 2005 subaru outback. while the vehicle was in reverse with the brake pedal depressed and extended to the floorboard, the vehicle continued to drive in reverse. upon inspection, it was discovered that brake fluid leaked from the brake lines and was present on the floor near the rear passenger wheel. the vehicle was towed to subaru of newport news (783 j clyde morris blvd, newport news, va) where it was diagnosed that the brake lines were damaged due to corrosion. the vehicle was not repaired. the manufacturer was not notified. the contact was informed that the vehicle was not included in nhtsa campaign number: 14v311000 (service brakes). the contact indicated that the vehicle experienced the same failure listed in the recall. the failure mileage was 183,000.
Tl* the contact owns a 2005 subaru outback. the contact stated that the brake line was rusted. due to the rust, brake fluid leaked from the brakes, which made it hard to stop the vehicle. the contact called john kennedy subaru (1201 e ridge pike, plymouth meeting, pa 19462, (610) 278-5000) and was informed that an unknown recall had expired; therefore, the contact would be responsible for the repair cost. the manufacturer was not made aware of the failure. the failure mileage was 182,000.
Purchased used october 2018 . received recall notice in mail and took to dealership november 2018 . recall was for driver airbag and rear brake line corrosion. airbag was replaced at that time and brake line was alledged to be inspected and coated . apr 2019 car pulled in front of vehicle and brakes were applied hard and rear brake line blew . no accident . car was towed to local mechanic and due to their knowledge of previous recall repairs was advised to car subaru directly . subaru was called and they advised to take back to dealership . the car was again towed . subaru reference number 1-43591235818. dealership claimed repairs were allegedly done and that subaru would not contribute to current situation . i contest that repairs were not properly done . it was easier to allegedly spray coating than to do repairs that were needed . coating a brake line that is already corroded is not a proper repair . photograph clearly shows this fact .
Brake system failure due to brake line corrosion ; driving vehicle and brakes failed, leaving me without ability to stop. luckily i was on a hardly-traveled road and getting home was uphill.
Recall was issued a few years ago for defect in the brake line allowing salt water to get in and cause corrosion to brake lines. brought to dealership and brake lines were sprayed with an anti corrosive. on 7/29/18, brake line was leaking and lost all brake prsssure while driving due to a corroded brake line.
4way connector brake line leaking causing no brakes. could of got in serious accident hazzard to drive called about recall on this but the said my car vin number was not listed and we're very rude and she hung up on me. had to put car in nutral to slow diwn
Tl* the contact owns a 2005 subaru outback. while pulling out of the driveway at 10 mph, the brake pedal traveled to the floor when it was depressed. the parking brake had to be applied to stop the vehicle. there were no warning indicators illuminated. the contact looked under the vehicle and noticed that all four brake lines failed. the vehicle was serviced per nhtsa campaign number: 14v311000 (service brakes); however, the remedy failed to repair the recall. the vehicle was towed to the local dealer. the local dealer (cascade auto group, 4149 state rd, cuyahoga falls, oh, 44223) diagnosed that the brake line was leaking where the recall repair was performed. the vehicle was not repaired. the manufacturer was contacted and provided case number: 1-25871335589. the manufacturer stated that the dealer was unwilling to assist with the repair cost and that the dealer cited the vehicle as having high mileage and a time sensitive recall. the manufacturer offered $500 towards the repair bill. the failure mileage was approximately 215,000.
Tl* the contact owns a 2005 subaru outback. the contact stated that while driving at approximately 30 mph and pressing the brake pedal to slow the vehicle down, the brake pedal extended to the floorboard and the vehicle did not immediately stop. the driver had to use the emergency brake to stop the vehicle. the vehicle was towed to an independent mechanic who diagnosed that the brake lines had failed do to excessive corrosion. the brake lines were replaced and the failure was remedied. the manufacturer and local dealer north town subaru of buffalo, new york were notified of the failure but no assistance was offered. the contact indicated that the vehicle was serviced in the january of 2015 under the nhtsa campaign number: 14v311000 (service brakes, hydraulic) and the brake lines were rustproofed with anti-corrosion wax but the failure still occurred. the failure mileage was 183,000.
Tl* the contact owns a 2005 subaru outback. while the vehicle was stopped at a light, the brake pedal was depressed and traveled to the floorboard. the vehicle was not diagnosed or repaired. the vehicle was serviced per nhtsa campaign number: 14v311000 (service brakes, hydraulic), but the remedy failed to repair the vehicle. the manufacturer was made aware of the failure and stated that the recall had expired. the failure mileage was approximately 192,000. the vin was not available.
Tl* takata recall. the contact owns a 2005 subaru outback. the contact received notification of nhtsa campaign numbers: 15v323000 (air bags) and 14v311000 (service brakes, hydraulic); however, the parts to do the repairs were unavailable. the contact stated that the manufacturer exceeded a reasonable amount of time for the recall repairs. the dealer (serra subaru of traverse city, 1747 s garfield ave, traverse city, mi) was contacted and confirmed that the parts were not available for the recall remedies. the manufacturer was notified and was not able to confirm when the parts were to become available. the contact had not experienced a failure. parts distribution disconnect.
Subaru outback 2005: the wire harness to the rear tailgate failed and shorted out the brake lights and reverse lights, creating a safety hazard while driving. *tr
On december 18, 2014 the day was clear; there had been no rain or snow that week. the pavement was dry. at the point of the issue i was in stop and go traffic, thus had used my brakes at an average of 12-18 times since i had left the house that morning. traffic was maybe moving at 20-25 miles an hour, stop and go. at one point i went to apply my brakes at a normal pressure and they started to pulse in the 'anti-lock' fashion. the pulses were exceptionally long, between braking (pulsing), nothing like i had ever experience before with this car or any other vehicle. however i kept my foot applied to the brake and did not try to pulse it myself. before i was able to get the car stopped it hit the car in front of me. i had about 1 and + car lengths between us, again only rolling and absolutely could not get the car stopped. the collision was not hard enough to deploy the airbag on either cars. the 2012 ford escape in front had nearly no damage to the rear bumper, however due to the placement of the ford's bumper to my grill, my repairs were $5,534.67. my fear is it happening again. due to the make of the car my insurance company can't access the electronic information on the day of the accident. thus they will not be part of my complaint that i have filed with subaru of america, filed 3/24/14. i done research on the subrau's abs system. i found that people have been disconecting their abs due to this issue. including finding youtube videos on how to do it. the issue is obvious if this is what people feel safer with than the subaru factory abs system. subaru's claim department has no interest in investigating it without my insurance being part of the claim, even thought i am a customer of their product that is defective. obviously this is not a customers claims department. who will handle my claim if the next incident i am severely injured or worse yet? *tr