Purchased this car listed in iaa website as having $68,000.00 miles, this week my mechanic told me that the car had $220,000.00 miles. i just checked carfax unfortunately that is a odometer rollback.
When i bought this car i found the top of the scissors jack was bent over, i replaced it with a very good junkyard replacement. last night i got a flat and when i jacked up the car. the top of the jack bent over just as the wheel was coming off the ground. it bent exactly the same way as the original. these are stamped steel jacks of a light steel and no bracing on the top riser and in my opinion, dangerous.
2004 subaru outback ll bean 3.0l h6 has history of intermittent unintended acceleration, misfire (surging) at highway speed, not slowing down with foot visibly not near gas pedal or brake pedal, acceleration in drive or reverse without touching brake or gas pedal, erratic idle. dealers attribute to bad sensor (replaced part number 22627aa130 sensor assy-press), dirty throttle body, gas treatment needed in gas tank, and they had never heard of such a problem ever (disbelief). also, when at its worst, symptoms include extreme (banging) shifts from 1st to 2nd gears. after owner reset ecm (disconnect battery, drained all known energy from electronics, reconnected battery) "service engine light soon"t came on, automobile operated normally, and "service engine soon" light went out within 50 miles of driving. this is an extremely dangerous situation due to unintended throttle inputs, speed not slowed with foot off throttle, and (obviously) impaired braking due to engine surge prior to full-stop. however, following full-stop, engine would slow down to near "normal" idle. file under, amazing, but true. *tr