on june 9, 2015 i brought my 2012 subaru forester (mileage 41184) into the subaru dealer for a "brake pipe inspection recall" and to replace a broken plastic molding in the front of the car. inspection by the mechanic at this time stated that all the brakes were in good shape according to their rating system. one month later, on july 8, 2015, i brought my 2012 subaru forester (mileage 42513) back to the subaru dealer because of vibration and noise emanating from the front of the car. inspection by the service mechanic showed that the front brakes had locked up, were not releasing, and had worn out the brake pads and scorched the front rotors from the heat generated by this malfunction. it was necessary for them to replace the rotors and pads. in a period of 30 days and 1329 miles the automobile went from good brakes to worn-out brakes with scorched rotors from the high heat generated. subaru is fortunate that i was aware something was wrong -- something which if not fixed could have caused a fire or brake failure while on busy highway and potentially resulted in bodily injury or death to the occupants. this is no way "normal" brake wear. the problem needs to be acknowledged and corrected by subaru before someone gets injured.
2012 subaru forester. consumer writes in regards to brake system failure recall notice. *smd the consumer stated from the day she purchased the vehicle, the brakes did not seem right. the brake pedal seemed too soft and there was extended pedal travel. she had to pump the brakes in order to stop in time. also, when sitting at a light with her foot on the brake pedal, the pedal would suddenly just sink downward an inch. also, at approximately, 17,000 in may 2014, the brakes began pulsating. the dealer machined the rotors and stated it was normal. the consumer even though the her year, was not included in the recall, she still experienced the same symptoms. *jb
Our forester has an inconsistent brake pedal. sometimes the pedal is firm and responsive. sometimes the pedal goes towards the floor before it responds. we never know how far in the pedal will go. thus far the brakes have always worked but extra time and distance are needed to stop. the problem is intermittent and has been there ever since we purchased the vehicle. the following from subaru's recall of other 2012 models explains almost exactly how this manifests for us. pressing the pedal lightly and subsequently having to hit the pedal harder without letting up seems to be a trigger. the pedal has also gone all the way to the floor on 2 occasions which occurred at very low speeds in parking lots. manifestations per the paragraph below are most common and can happen at any speed including on the highway. in the recall letter sent to subaru owners it noted that "in vehicles experiencing this condition, the driver will initially encounter a soft pedal feel and may momentarily perceive a sense of loss in braking power while the pedal is being pressed lightly. this will only continue until the pedal is pressed downward approximately 2 more inches. effective braking function will be achieved at that point, making it possible to slow or stop the vehicle." we have taken the vehicle to 2 dealerships and they both told us there is no problem. we returned the vehicle to one of the dealerships and they road tested it for 3 days and told us nothing is wrong. we appear to have the same problem that triggered a recall of millions of other 2012 models and we do not appear to be taken seriously. this problem is potentially life threatening, and it needs to be dealt with regardless of whether it manifests for subaru technicians or not. i have taken the vehicle to my mechanic and he believes the master cylinder is bad but he has done no work on the vehicle. *tr