Disclaimer: Not affiliated with or endorsed by RAM Motor Company. For informational purposes only. Full Disclaimer

2019 RAM 2500 Owners Manual - POWER SUNROOF — IF EQUIPPED



POWER SUNROOF — IF EQUIPPED

The power sunroof switches are located on the overhead console between the courtesy/reading lights.

Power Sunroof Switches

1 — Opening/Closing Sunroof 2 — Venting Sunroof

Express

Push the switch rearward and release it within one-half second. The sunroof and sunshade will open automatically and stop when the full open position is reached. This is called “Express Open.” During Express Open operation, any other actuation of the sunroof switch will stop the sunroof.

Manual Mode

To open the sunroof, push and hold the switch rearward. The sunroof will move rearward and automatically stop at full open position. Any release of the switch will stop the move- ment. The sunroof and sunshade will remain in a partially opened condition until the sunroof switch is pushed again.

Express

buffeting. If the buffeting occurs with the sunroof open, adjust the sunroof opening to minimize the buffeting or open any window.

Push the switch forward and release it within one-half

second and the sunroof will close automatically from any position. The sunroof will close fully and stop automatically. This is called “Express Close.” During Express Close opera- tion, any other actuation of the switch will stop the sunroof.

Manual Mode

To close the sunroof, push and hold the switch forward. The sunroof will move forward and automatically stop at full closed position. Any release of the switch will stop the move- ment and the sunroof will remain in a partially closed condi- tion until the sunroof switch is pushed again.

Wind buffeting can be described as the perception of pres- sure on the ears or a helicopter-type sound in the ears. Your vehicle may exhibit wind buffeting with the windows down, or the sunroof (if equipped) in certain open or partially open positions. This is a normal occurrence and can be minimized. If the buffeting occurs with the rear windows open, then open the front and rear windows together to minimize the

The sunshade can be opened manually. However, the sunshade will open automatically as the sunroof opens.

NOTE:

The sunshade cannot be closed if the sunroof is open.

This feature will detect an obstruction in the closing of the sunroof during the Express Close operation. If an obstruction in the path of the sunroof is detected, the sunroof will auto- matically retract. Remove the obstruction if this occurs.

NOTE:

If three consecutive sunroof close attempts result in Pinch Protect reversals, Pinch Protect will disable and the sunroof must be closed in Manual Mode.

Push and release the Vent button within one half second and the sunroof will open to the vent position. This is called “Express Vent”, and it will occur regardless of sunroof posi- tion. During Express Vent operation, any other actuation of the switch will stop the sunroof.

Use only a non-abrasive cleaner and a soft cloth to clean the glass panel.

The power sunroof switch will remain active for up to approximately 10 minutes after the ignition switch is turned to the OFF/LOCK position. Opening either front door will cancel this feature.

NOTE:

Ignition Off time is programmable through the Uconnect System. Refer to “Uconnect Settings” in “Multimedia” for further information.

For vehicles equipped with a sunroof, there is a relearn procedure that allows you to calibrate the sunroof when the “Express Operation” feature stops working. To reset the sunroof, follow these steps:

    Set the ignition to the ACC or the ON/RUN position.
    Ensure that the sunroof is in the fully closed position.
    Push and hold the close switch. The sunroof will hit the hard stop and move to the vent position after ten seconds.
    Release the close switch.
    Push and hold the close switch again within five seconds to begin the teaching process. The sunroof will complete one full cycle and return to the fully closed position.

NOTE:

If the close switch is released anytime during the teach cycle, the procedure will need to be repeated starting from the first step.

    Once the sunroof has stopped in the fully closed position, release the close switch. The sunroof is now reset and ready to use.

Download Manual