The bracket for the clutch pedal has broken 4 times. the milage is currently 81,000. i've contacted mazda corp and the dealer i bought it from new. they're saying unless there's a recall we have to keep buying a new pedal/bracket assembly. the metal they used is soft and weak causing you to lose control of the clutch. pedal gets stuck too. it happens while driving and at idle. dangerous going up or down hills even at intersections it'll disable your ability to move. when mazda does a repair the put the same weak junk not bothering to reinforce or even fix their problem. look it up on the web. just about everyone with a manual rx8 has the same problem.
My vehicle experienced a defect known to mazda to the extent of them issuing a recall (or ssp) in the canadian market due to use of corrosives and excessive wet seasons causing build up on and corrosion of the oil cooler lines. mazda clearly stated in the canadian ssp (#76) that extensive corrosion could cause a leak and/or loss of pressure, and knowing that a loss of pressure or a significant amount of oil while the car was in operation would cause drastic mechanical engine failure by way of burning out the seals/rotors/bearings and eventual seizure or total loss of compression in the motor. the loss of oil pressure due to corrosion directly resulting from this caused my apex seals to overheat and no longer provide a seal to allow the motor to hold compression. due to this failure directly caused by the known defect, and the fact that the issue was put in place for canada due to their high propensity for extended wet seasons and high use of corrosives to alleviate wintery conditions on the roadways, mazda should also have issued regional or case-by-case recalls of vehicles that experience this same defect in areas of the united states that experience similar conditions. had i been travelling on the highway and not on a 25mph city road, i could have experience a major accident or incident because of my motor failure. there are numerous other cases of this defect showing in american vehicles across the country, from near me (in new england) to california that have been reported online. i can contact the licensed mechnic who dealt with the vehicle for copies of his work orders, and i have receipts to prove that i purchased oil cooler lines as replacements before i knew of the loss of compression and ruined motor. mazda usa was of no help in alleviating the problem, and i am now out thousands of dollars on a vehicle that i had recently purchased before the event occurred
Clutch pedal assembly snapped in half at weld point, while shifting at normal speeds on highway.
2006 mazda rx8 shinka failed clutch pedal while driving in local area. i took it to machinist next door, and he told me that this pedal is unbelievable how weak it is. the metal part which holds clutch pedal is very thin. now i've been charged around $400 to fix it, and it feels like it is mazda's fault. i couldn't go to school yesterday, and my school is private college, so i wasted another $150 missing one day of class. *tr