Disclaimer: Not affiliated with or endorsed by Mazda Motor Company. For informational purposes only. Full Disclaimer

Problems with 2010 Mazda Mazda6 SERVICE BRAKES, HYDRAULIC

On average, the 2010 Mazda Mazda6 starts to “feel” problems with the SERVICE BRAKES, HYDRAULIC and its various aspects after 8 673 miles.

Recently reported SERVICE BRAKES, HYDRAULIC problems on 2010 Mazda Mazda6

Tl* the contact owns a 2010 mazda mazda6. the contact stated that the rotors were prematurely warped, causing the vehicle to jerk violently. also, the contact mentioned that the tpms and passenger air bag warning lamp illuminated. the vehicle was taken to the dealer. the technician was unable to diagnose the failure. the manufacturer was made aware of the failure. the vehicle was not repaired. the vin was not available. the failure mileage was 30,000 and the current mileage was 60,000.

Brake sensor making noise as if the brakes need to be replaced. vehicle has under 10000 miles. have owned several new vehicles and have never had to replace the brakes for a new vehicle at this number of mileage. possible defect with mazdas braking system. *tr

My 2010 mazda 6 which has less than 10,000 miles on it has been reported by the service center that all 4 rotors are out of round and need to be replaced. however, the brakes and brake pads are fine. the warranty will not cover the replacement of the rotors. another issue is when i turn the steering wheel to the right the horn will randomly start beeping. the service center stated it did not happen for them. *tr

When applying foot to the brakes, the pedal "collapse" to the floor with little to no resistance. releasing the brake pedal and quickly pumping does regain some resistance, but braking is affected. the problem is intermittent and is not triggered by any specific event. *tr

Other 2010 Mazda Mazda6 Problem Categories