Disclaimer: Not affiliated with or endorsed by Jeep Motor Company. For informational purposes only. Full Disclaimer

Problems with 2000 Jeep Wrangler SEAT BELTS

On average, the 2000 Jeep Wrangler starts to “feel” problems with the SEAT BELTS and its various aspects after 17 500 miles.

Components Affected by SEAT BELTS Issues

We have classified the 5 complaints from 2000 Jeep Wrangler about SEAT BELTS into the following categories.

FRONT 3

Recently reported SEAT BELTS problems on 2000 Jeep Wrangler

1) i bought the jeep wrangler used 2)the latch sometimes does not engage when i put the lip of the seat belt into the socket of the seat belt. it sticks...im afraid that if i do get in a wreck it will fail and i will be ejected, especially with a jeep and it having a high rollover risk. 3)im seriously thinking of getting brand new seat belts, not chrysler brand but after market ones, unless chrylser solves the issue. *jb

All four seat belt release mechanisms get stuck. i have had to assist passengers with releasing the seat belt after they attempted it themselves. to release the belts, there must be sufficient slack in the belt to allow an angle between the tongue and receptacle opposite the angle naturally achieved when in use. this problem was very noticeable but not as bad when the vehicle was new. no one has been injured in my vehicle, but when passengers need assistance removing a safety belt, that is a potential safety issue. *nm

dt: contact states the driver side seat belt works part of the time, other times it won?t pulled out far enough to latch. the service dealer stated the entire unit of the seat belt needed to be replaced. *ak seat belt will not retract, vehicle has been taken to several different shops to be fixed and found out that seat belts had been redisgned but not recalled.consumer believes that since there was a redesign in the seat belts then it must have been a safety problem

The passenger side retractor failed when applied. consumer placed the seat belt inside the retractor and it failed to stay secure. *ak

My drivers seat belt will pop open when i stop or turn or lean forward.

On feburary 1, 2003, my daughter was driving a 2000 jeep wrangler at about 35 mph on a slight up-grade. she left about 20' of straight skid prior to a rear-end collision. slight deformation to the bumper, a small dent and broken turn signal lens on right fender. she was wearing the seat belt and shoulder strap, yet sustained a broken nose and broken cheek bone from hitting the steering wheel. no airbags deployed. the shoulder strap did not prevent forward motion. where can i get this vehicle examined and what information do you have regarding these specific devices? thank you, very much. *jb

Seat belt on drivers side does not retract due to detioration of plastic sleave in retraction holder. *jb

Please recall the gen 3 type seatbelt! this is a proactive complaint to prevent an incident, thus you will not find a date below.

On numerous occasions while connecting the seatbelt the buckle goes into the reciever but does not go in properly. it goes in and feels like it connected but doesn't latch. driving down the road the belt will release.

No summary listed for abov evehicle. *ak

I have ongoing problem with seatbelt similar to several i have already seen reported in that the belt appears to lock but is not actually engaged. it then slips out of latch while driving. has to be inserted at precise angle in order to catch and takes several trials to make this happen. *tr

Seat belt is flapping and rubbing against seat. *ak

Other 2000 Jeep Wrangler Problem Categories