After starting car and driving emergency break engages and car shuts off while in motion. upon turning off, "low oil pressure" warning comes up for less than 3 seconds and then disappears.. and engine stays off. takes about 5-7 minutes for car to turn back on. this has occurred multiple times while driving on interstate highway and busy intersection. super dangerous and not safe... have called jeep to open a case and taking in for servicing. this is not ok. truck is less than 6 months, not even 3,000 miles.
Factory trailer tow option lighting control shuts lights off on trailer and indicates turn signal light out when lights are fine. left turn signals and brake light malfunction. multiple trailers tested. dealer has replaced trailer control module twice and problem persists. still no resolution to problem. this results in an unsafe condition when towing.
Tl* the contact owns a 2018 jeep compass. the contact stated that the vehicle failed to start when the remote start feature was pressed on the key fob. also, the auto stop indicator remained illuminated even when the feature was set to off. the contact also stated that there was a coolant leak and the emergency brake warning indicator was illuminated while the vehicle was being driven. in addition, the automatic headlamps were illuminated and, when using the remote start feature in cold weather, the heated seats would not operate and the defroster would not activate. the contact was concerned that cold air from the air conditioning unit would be activated instead. the vehicle was taken to griffin motor company (located at 11031 perry hwy, meadville, pa 16335, (814) 336-2161) to be diagnosed. the contact was informed that there was no evidence of a coolant leak. the mechanic was also able to use the remote start feature to start the vehicle. there were no repairs performed on the vehicle. the manufacturer was not contacted. the approximate failure mileage was 7,500. *bf consumer stated rear wiper,door lock and remote sporadically works. also, fluid release just under engine area and auto stop (engine) function as well as emergency brake and electrical system malfuction.*jb
Turn signal failure. signal lights do not blink when the driver seatbelt is unbuckled. unrestrained driver does not have any functional turn signals. turn signal lever depression or elevation has no effect on external signal lights, internal arrows on dash or relay box clicking. no external blinkers, no illuminating signal arrows which usually illuminate in your dashboard console when the signal lever is depressed, no sound (signal clicking) inside of the vehicle while signal lever depressed. the signals function normally when the driver seatbelt is buckled. this is a constant problem and has never functioned normally.
The dash lights do not dim when transitioning from day to night driving. i have to pull the vehicle over, turn it off, wait a few minutes and restart. sometimes it takes three or four tries before the lights dim. additionally, the reverse camera display does not dim at night. i have almost backed into a ditch and a tree because i was blinded by the camera display. usually i have to put something over it while backing up at night in order to do so safely. very poor design in both the dash and reverse camera dimming technology. it's not like the dimming feature is new technology!
Navigation screen lighting is at highest setting while in reverse. the back up screen is so bright that the driver is temporarily blinded by the extreme brightness of the screen then returns to normal when put in drive. this happens at any brightness setting of the instrument panel.
1 unable to turn the radio volume up or down. turned car off and on. would not turn off accessory mode. message stating car was on. picture to be provided. turned on and off multiple times. problem was corrected next time i started it. 2 while driving accessory deactivated. would not turn on. problem corrected itself hours after leaving it parked. picture of error message to be provided. 3 my jeep was unable to stop at a yellow light. stopped in middle of interscetion, almost a crash. rainy weather.
I bought my jeep compass 2018 in april of 2018. when i was finally able to drive it at night i realized the touch screen and instrument panel did not dim when the headlights came on as it says that it will do. it makes it very difficult to drive at night with how bright the displays are. *tt *tr
Instrument panel lights will not dim on automatic lights setting or when display lights have been on for longer then 8 seconds. the dash lights and stereo lights are too bright to drive at night. have to stop car, turn off car along with turning off all light switches. have to wait for at least a minute then can start the car and adjust the brightness before has been on for 8 seconds. when on interstate this is not possible to do. need to be able to display dash and should work automatically. doesn't matter whether parked or moving. lights will not work on the automatic setting. others have complained. please see this youtube.com video because our issue is the same. https://www.youtube.com/watch?v=6ajaaemp7w8
Instrument gauge cluster lights do not dim with dimmer dial. dash lights are bright enough to turn the windshield into a mirror at night (see insider vehicle better than outside).
Instrument cluster is very bright at night, affecting the ability to see the roadway. instrument cluster does not dim when attempting to adjust brightness. instrument cluster does not adjust to compensate from daylight to darkness. vehicle does not seem to recognize that the headlights are on. the option to adjust brightness, with the headlights on, is not available due to vehicle's inability to recognize that the headlights are on. rear view camera is extremely bright at night, affecting the ability to recognize probable hazards in roadway. due to this brightness, the eyes take time to readjust to the dark environment when vehicle is put back in drive. these issues occur when the vehicle is in motion and stationary.
Instrument cluster lighting control including dimmer, headlight 'on' sensor, dash ambiant light sensor, related software do not function properly. unable to dim dash at night with dimmer control & or 'auto night dim' does not function. the blinding brightness of the dash at night is not only discomforting it is hazardous. this fault is well documented on internet forums & youtube videos.
1. instrument panel lighting cannot be dimmed: blinds driver during night driving. 2. the speedometer scale does not change from mph to kph. this becomes very problematic when crossing from the us to canada!
The instrument panel dimmer switch is inoperable. the speedometer, and entire gauge cluster, is stuck on full brightness during nighttime driving and is very dangerous as it is blindingly bright in my face.
The interior instrument panel and console lighting will not dim at night. this leads to a blinding situation. the dimmer switch functions only intermittently but the ip lights will go full bright after a short while after a vehicle restart. this occurs whether or not the car is moving or parked. headlights are switched on to auto. the lights behave this way day or night. appears to be a sensor issue.
Instrument panel lighting fails to dim properly at night causing difficulty seeing at night due to the brightness of the display. i am able to get the display to be tricked into going into "night mode" if the display light sensor has no light at vehicle startup with headlights on. at any time if the sensor is exposed to light again such as if a door is opened or interior light is turned on the vehicle needs to be stopped, doors locked, and sitting for one minute for the workaround to be successful again.
The vehicle's dash board lighting dimming function is not working and impairing the drivers night vision always being at the highest setting. reporting this issue as this is not only affecting a single vehicle, but multiples. the jeep headquarters were contacted by multiple effected owner as evident in the reference forum post, but jeep does currently not take action. reference posts: http://www.myjeepcompass.com/forums/2nd-gen-jeep-compass-forum-general-discussion/35673-dash-lights-do-not-dim.html http://www.myjeepcompass.com/forums/2nd-gen-jeep-compass-forum-general-discussion/34985-dash-screen-not-dimming.html
Dimmer for dash lights / gauges does nothing. all interior gauges, controls, dials, etc. stuck on full brightness. very dangerous - makes it hard to operate vehicle at night with glaring gauges.
Instrument cluster is very bright at night, affecting the ability to see the roadway. instrument cluster does not dim when attempting to adjust brightness. instrument cluster does not adjust to compensate from daylight to darkness. rear view camera is extremely bright at night, affecting the ability to recognize probable hazards in roadway. due to this brightness, the eyes take time to readjust to the dark environment when vehicle is put back in drive. these issues occur when the vehicle is in motion and stationary.
In violation of fmvss section s 5.3.2.2 (b) the vehicle's interior dashboard lights are not capable of being dimmed. they remain at brightest level regardless of any parking or headlight settings, and cannot be dimmed or turned off. this creates a dangerous condition during night time vehicle operation. dealer has not been able to correct this even after two visits, and has made no progress in resolving this issue since vehicle purchased one month ago.
Multiple issues with car display, and dimmer capabilities. navigation screen and backup camera blindingly bright when dark out, creating safety hazard. had instrument panel cluster software update recall work completed but issue not resolved with recall work. problem persists when vehicle is in motion and stationary. *tt
The interior instrument panel and console lighting will not dim at night. this leads to a blinding situation. the dimmer switch functions only intermittently but the ip lights will go full bright after a short while after a vehicle restart. this occurs whether or not the car is moving or parked. headlights are switched on. the lights behave this way day or night. i noticed the problem after taking delivery on 9-27-2017
The dimmer switch for dashboard and screen lights do not dim. at night the light is so bright that it creates a glare.
Instrument panel dimmer does not work causing extreme brightness at night. navigation panel does not switch to nighttime mode causing it to be a safety hazard if using while dark out. backup camera is blinding at night, creating safety hazard. this occurs while stationary, while moving, during all types of driving when dark out. this has been an on-going issue from the day i bought the car with no resolution from the dealer.
Jeep will not allow dimming of the instrument panel or nav screen at night due to a light sensor in the instrument panel. shown in the following video https://www.youtube.com/watch?v=6ajaaemp7w8&list=plxmx4zwlio2wjzsq8syupaesc_r8g-qto
I had my vehicle diagnosed due to interior lights do not dim at night leaving the jeep very bright and dangerous. i have called jeep and they refuse to fix the issue or give me a solution on what to do! they still refuse at of today 9/26/17.
Speedometer light and the center dash (gps, radio, uconnect) screen illumination can not be dimmed at night using the rotary knob (wheel) located on the left side of the dash. the illuminaton coming from these screens is incredibly bright, especially when traveling on rural roads where deer, ferrel hogs and other wild animals run into the roadway. i can not see these obstacles and believe this is a severe safety hazard for any driver who travels on non-illuminated roads. the light from my speedometer can not be dialed down when the vehicle is sitting idle, or in drive and when parked or in motion. it has never worked properly and the dealership is not able to determine what the problem is. they are clueless and since the dealership open after 5 pm to observe this problem during hours of darkness. numerous other jeep compass owners 2017 and 2018 model years, have complained of this same problem. deer are the same color and contrast of gray asphalt and they are nearly impossible to see at night, due to the overwhelming illumination from the center display and speedometer brightness. this problem has been occurring since my purchase 3 months ago and continues to this evening. i plan on uploading a video to youtube soon. i am retired from film and television and taught this subject at a private university here in texas.
When using the back-up camera, the license plate lights shine into the camera and the brightness is practically blinding. it extremely difficult to judge/maneuver the car, even if using the mirrors ,and not the camera, to back-up. there is no way to adjust the brightness manually. if other cars/people are in the vacinity, it may cause a safety issue.