We have classified the 1 complaints from 2019 Ford Fusion about VEHICLE SPEED CONTROL into the following categories.
With cruise control set, pressing the + button and holding for a few seconds to increase the speed a few mile per hour will cause the vehicle to continue accelerating until the 'cancel' button or the 'off' button is pressed. pressing the brake pedal will also stop the run away acceleration. during the run-away accelerating, pressing the + button or the - button will not stop the acceleration. additionally, with cruise set, pressing the - button for a few seconds will cause a run-away deceleration. the vehicle is presently being looked at by the dealership where it was bought. in the mean time, i was given a 2019 fusion hybrid as a loaner vehicle and that cruise control does the same thing: run-away acceleration and deceleration when pressing the + or - button. the vehicle was checked many times and was cruising anywhere from 50 mph to 70 mph when the + and - button was pressed. i noticed that the run-away deceleration was quite pronounced compared to the acceleration.
Tl* the contact owns a 2019 ford fusion. while attempting to accelerate from a stop, the accelerator pedal seized. when the contact turned off and restarted the vehicle, the accelerator pedal returned to normal. in addition, the contact stated that the brakes seized while in traffic this week, which almost caused a crash and the check manual warning message illuminated. the vehicle was taken to flammer ford (3335 commercial way, spring hill, fl 34606, (352) 686-8255) where it was diagnosed that an auto stop/start module needed to be installed. the vehicle was not repaired, but an appointment was scheduled for april 9, 2019. the manufacturer was made aware of the failure and would not allow the dealer to repair the vehicle because the diagnostic trouble code could not be read during the diagnostic test. the failure mileage was 8,070.