Parking Aids
|
|
WARNING: To help avoid personal injury, always use caution when in reverse (R) and when using the sensing system.
WARNING: The system may not detect objects with surfaces that absorb reflection. Always drive with due care and attention. Failure to take care may result in a crash.
WARNING: Traffic control systems, inclement weather, air brakes, external motors and fans may affect the correct operation of the sensing system.This may cause reduced performance or false alerts.
WARNING: The system may not detect small or moving objects, particularly those close to the ground.Note: Certain add-on devices installed around the bumper or fascia may create false beeps. For example, large trailer hitches, bike or surfboard racks, license plate brackets, bumper covers or any other device that may block the normal detection zone of the system.
Note: Keep the sensors, located on the bumper or fascia, free from snow, ice and large accumulations of dirt. If the sensors are covered, the system’s accuracy can be affected. Do not clean the sensors with sharp objects.
Note: If your vehicle sustains damage to the bumper or fascia, leaving it misaligned or bent, the sensing zone may be altered causing inaccurate measurement of obstacles or false alarms. See your authorized technician.
Note: When a trailer is connected to your vehicle, the rear parking aid may detect the trailer and therefore provide warnings.
Disable the rear parking aid when a trailer is connected to prevent these warnings.
Note: The sensing system cannot be turned off when a MyKey is present. See Principle of Operation (page 60).
The sensing system warns the driver of obstacles within a certain range of your vehicle. The system turns on automatically whenever you switch the ignition on.
When receiving a detection warning, the radio volume reduces to a predetermined level. After the warning goes away, the radio volume returns to the previous level.
The sensing system can be switched off through the information display menu or from the pop-up message that appears once you shift the transmission into reverse (R). See General Information (page 109).
If a fault is present in the system, a warning message appears in the information display and you cannot switch the system on through the pop-up message. See Information Messages (page 120).
The rear sensors are only active when the transmission is in reverse (R). As your vehicle moves closer to the obstacle, the rate of the audible warning increases.
When the obstacle is less than 11.81 in (30 cm) away, the warning sounds continuously. If the system detects a stationary or receding object farther than
11.81 in (30 cm) from the corners of the bumper, the tone sounds for only two seconds. Once the system detects an object approaching, the warning sounds again.
228
E231381
The coverage area is up to 6 ft (1.8 m) from the rear bumper. The coverage area could decrease at the outer corners of the bumper.
The system detects certain objects while the transmission is in reverse (R):
(5 km/h) or less.
The system provides audio warnings only when your vehicle is moving or when your vehicle is stationary, and the detected obstacle is less than 12 in (30 cm) away from the bumper.
The system provides obstacle distance indication through the display screen. See Rear View Camera (page 229).
The rear view camera system displays what is behind your vehicle when you shift the transmission into reverse (R).
During operation, lines appear in the display that represents the path of your vehicle and proximity to objects behind it.
229
The rear view camera is located on the tailgate.
The system uses three types of guides to help you see what is behind your vehicle:
Active guidelines: Show the intended path of your vehicle when reversing.
Fixed guidelines: Show the actual path your vehicle is moving while reversing in a straight line. This can be helpful when backing into a parking space or aligning your vehicle with another object behind you.
Centerline: Helps align the center of your vehicle with an object (for example, a trailer).
Note: If the transmission is in reverse (R) and the tailgate is ajar, no rear view camera features are displayed.
Note: If the image does not turn off while the transmission is not in reverse (R) and you are driving over a speed of 5 mph
(8 km/h), have the system inspected by an authorized dealer.
Note: When towing, the camera only sees what is being towed behind your vehicle. This might not provide adequate coverage as it usually provides in normal operation and some objects might not be seen. In some vehicles, the guidelines may disappear once the trailer tow connector is engaged.
The camera may not operate correctly under the following conditions:
Nighttime or dark areas if the reverse lamps are not operating.
Mud, water or debris obstructs the camera's view. Clean the lens with a soft, lint-free cloth and non-abrasive cleaner.
The camera is misaligned due to damage to the rear of your vehicle.
Note: Active guidelines and fixed guidelines are only available when the transmission is in reverse (R).
Note: The centerline is only available if Active or Fixed guidelines are on.
Note: Some vehicles may not come equipped with guidelines.
230
Always use caution while reversing. Objects in the red zone are closest to your vehicle and objects in the green zone are farther away. Objects are getting closer to your vehicle as they move from the green zone to the yellow or red zones. Use the side view mirrors and rear view mirror to get better coverage on both sides and rear of your vehicle.
E142436
A B C D E F
Active guidelines Centerline
Fixed guideline: Green zone Fixed guideline: Yellow zone Fixed guideline: Red zone
Rear bumper
E190459
The system will provide an image of your vehicle and the sensor zones. The zones will highlight green, yellow and red when the parking aid sensors detect an object in
To use active guidelines, turn the steering wheel to point the guidelines toward an intended path. If the steering wheel position is changed while reversing, the vehicle might deviate from the original intended path.
The active guidelines fade in and out depending on the steering wheel position. The active guidelines are not shown when the steering wheel position is straight.
the coverage area.
Selectable settings for this feature are ON and OFF.
231
When shifting the transmission out of reverse (R) and into any gear other than park (P), the camera image remains in the display until:
Allows you to see a top-down view of the area outside your vehicle, including the blind spots.
Provides visibility around your vehicle to you in parking maneuvers such as:
Centering in a parking space.
Obstacles near vehicle.
Parallel parking.
The camera button is on the instrument panel. Pressing the camera button activates the
Note: The 360 degree camera system turns off when your vehicle is in motion at low speed, except when in reverse (R).
The 360 degree camera system consists of front, side and rear cameras. The system:
Allows you to see what is directly in front or behind your vehicle.
Provides cross traffic view in front and behind your vehicle.
system.
When in park (P), neutral (N) or drive (D), only images from the front cameras are displayed. Press the camera button to display the front camera image on the display screen.
When in reverse (R), only images from the rear cameras are displayed. When you shift into reverse (R), the rear view camera image automatically shows on the display screen.
Additional camera views may be available for vehicles with specific features. Press the small
camera icon shown on the top left corner of the display screen to open the camera view menu.
The following camera views can be accessed in park (P), neutral (N) or drive
(D) when you press the camera button:
Front 360 + Normal: Contains the normal front camera view next to a 360 degree camera view.
Front Normal View: Provides an image of what is directly in front of your vehicle.
232
The following camera views can be accessed when you shift into reverse (R):
E184448
The Keep Out Zone is represented by the yellow dotted lines running parallel to your vehicle. It is designed to give you the indication on the ground of the fully extended outside mirror position.
|
|
WARNING: The front camera system still requires the driver to use it in conjunction with looking out of your vehicle.233
The front video camera is in the grille and provides a video image of the area in front of your vehicle. It adds assistance to the driver while driving forward at low speeds. To use the front video camera system, place the transmission in any gear except reverse (R). An image will display once the camera enable button is pressed. The area displayed on the screen may vary according to your vehicle's orientation or road condition.
Bed View Camera (If Equipped)
The bed view camera system is a variant of the rear view camera that is mounted within the high-mount stop lamp. It is designed to display the contents of your truck bed or assist you when backing up to align and hitch a fifth wheel or gooseneck trailer. The bed view camera is not meant as an alternative to the rear view camera.
The side view camera is in the outside mirror and provides a video image of the area on the sides of your vehicle. It aids you while parking your vehicle, or when parking with a trailer attached.
Note: Use caution when using the 360 view while any of the doors are ajar. If a door is ajar, the camera will be out of position and the video image could be incorrect.
E233763
The camera view contains a dynamic guideline to help you locate the center of your vehicle. This view can be accessed while in drive (D) or reverse (R).
Note: The auxiliary camera works with trailers up to 50 ft (15 m) in length.
234
(R).
Access the auxiliary camera view by pressing the button on the display screen when in reverse
Access the auxiliary camera while in drive
(D) by pressing the camera button twice.
The auxiliary camera system is a variant of the rear view camera. It is designed to display a rear view image from the back of a trailer while reversing. The auxiliary camera is not meant as an alternative to the rear view camera.
235
Download Manual