Problems with 2014 FIAT 500L STRUCTURE

Dec 23 2015 vehicle has 35,000 miles on it and the transmission went out in our driveway every gear was neutral. it was in the shop for 38 days before we received it back. all repairs done under warranty. feb 9 2017 while in a parking lot the vehicle was put into reverse however the vehicle started to roll forward causing my wife to crash into a concrete pole in the parking lot damaging the front end. i contacted fiat customer care about the incident and they told me to take it to the dealer and after alot of talks they said they would fix the transmission error but not the damage it did i fixed other repairs so the vehicle could still be driven. sept 15 2017 while driving in congested traffic vehicle was smoking and shifting rough would roll backwards if gas pedal was not fully depressed to the floor. now we get the recall notice that states basicaly what we have been describing. have not been able to take it to the dealer being that it is far away and have no other transportation. nov 24 2017 while at a light the vehicle started making grinding noises and smelling like burning trans fluid then started to roll backwards almost hitting another vehicle will be taking it to the dealer on nov 28th for recal and look into the other issues like hesitation while pressing gas pedal making left hand turns scary when on coming traffic is near.

A misalignment of the left front corner panel and the side panel, as well as a misalignment of the left rear corner panel and the side panel have taken place (see pictures). the dealership states that it is because of an "impact." i believe that there is a problem in the "clips" that hold the panels together. under the rear bumper, there is a crack in the plastic by the muffler (see picture). that was probably caused by backing into a snowbank. there are no other "scratch" marks on the underside of the rear bumper, and there are no scratch marks (caused by hitting something) under the front bumper. there are no issues on the right side of the car. i will accept the fact that i may have backed into a snowbank. however, if that caused the panel separation, there must be something wrong with the way the panels are connected. with the front panels, i am amazed that an "impact" that shows no visible marks would be sufficient to cause the panels to separate/misalign. i am concerned that if the "clips" that connect the panels are that weak, that this could be a safety issue if there was any actual impact. i indicated a date when this happened, but i am not sure if that was when i first noticed it.

After asking i was told that the issue is called cabin pressure. this occurs at all speeds over 20mph the pressure interferes with your ability to hear. gives you almost a headache it hurts your ears. it occurs when a window is rolled down more then 1 inch. sometimes you can stop it by rolling down another window but sometimes you have to roll down a 3rd window to make it stop. it is worse when the window is rolled down 1/4 of the way or more. *js