We have classified the 1 complaints from 1999 Dodge Ram 3500 about EXTERIOR LIGHTING into the following categories.
Tl* the contact owns a 1999 dodge ram 3500. the contact stated that while driving at 65 mph, the park lamps, fog lights, exterior roof lights and the tail lights failed. the contact stated that while attempting to replace the headlamp switch, he noticed that the switch and wiring harness had melted. the vehicle was not diagnosed or repaired. the vehicle was not included in nhtsa campaign number: 99v024000 (exterior lighting). the manufacturer was notified of the failure. the approximate failure mileage was 288,000.
Tl*the contact owns a 1999 dodge ram 35000. the contact stated that the headlights would flicker on and off then illuminate after two seconds. the contact replaced the headlight switch, bulbs and wires; however, the failure continued to occur. the failure mileage was 292,000 and current mileage was 292,492.
While driving at any speed and without warning, applied on brakes and vehicle would pull to the left or right. dealer has been notified. dealer has serviced vehicle before for same problem; however has not found remedy for malfunction.*ak consumer adds after front pads were replaced front/rear brakes continue to lock up. while opposite end wheels roll free. many attempts made to correct problem, but lock up still happens frequently. steering seems very loose and is hard to keep vehicle straight. power steering gear and steering gear box was replaced however truck continues to wander. driver side seat cushion saggs. seat bottom cushion replaced. cab sqwaks on uneven ground. black smoke from exhaust when cold or warm. clutch slips. dealer could not duplicate. dimmer on dash lights burns fingers. when turning on turn signals, wipers will activate and rapid flash is heard. difficulty getting into first gear. abs jams when under a hard stop and during cold start. lumbar is inoperative. tranmsission leaking oil. replaced output shaft seal. master cylinder replaced. most gears difficult to engage. reverse is very stiff. shifting 2-3rd will cause shifter to lock up and won't move at all. no problem found. overhead console inoperative and replaced. *tt