REMOTE START — IF EQUIPPED
How To Use Remote Start — If Equipped
Push remote start button on the key fob twice within five seconds. Pushing the remote start button a third time shuts the engine off.
To drive the vehicle, push the unlock button, and push the ignition to the ON/RUN position.
NOTE:
With remote start, the engine will only run for 15 minutes (timeout) unless the ignition is placed in the ON/RUN position.
The vehicle must be started with the key after two consecutive timeouts.
All of the following conditions must be met before the engine will remote start:
The following messages will display in the instrument
NOTE:
If an engine fault is present or fuel level is low, the vehicle will start and then shut down in 10 seconds.
cluster display if the vehicle fails to remote start or exits
remote start prematurely:
The message will stay active until the ignition is turned to the ON/RUN position.
Push and release the remote start button on the key fob twice within five seconds. The vehicle doors will lock, the parking lights will flash, and the horn will chirp twice (if programmed). Then, the engine will start, and the vehicle will remain in the Remote Start mode for a 15-minute cycle.
Remote Start mode.
For security, power window and power sunroof opera- tion (if equipped) are disabled when the vehicle is in the Remote Start mode.
The engine can be started two consecutive times with the key fob. However, the ignition must be cycled by pushing the START/STOP button twice (or the ignition switch must be cycled to the ON/RUN position) before you can repeat the start sequence for a third cycle.
Push and release the remote start button one time or allow the engine to run for the entire 15-minute cycle.
NOTE: To avoid unintentional shutdowns, the system will disable with a one time push of the remote start button for two seconds after receiving a valid remote start request.
Before the end of 15-minute cycle, push and release the unlock button on the key fob to unlock the doors and disarm the vehicle security alarm (if equipped). Then, prior to the end of the 15-minute cycle, push and release the START/STOP button. If the START/STOP button is not present, insert the key fob into the ignition switch and turn the switch to the ON/RUN position.
NOTE:
For vehicles not equipped with the Keyless Enter-N-Go
For vehicles not equipped with the Keyless Enter-N-Go
For vehicles equipped with the Keyless Enter-N-Go — Passive Entry feature, the message “Remote Start Active
To Cancel Remote Start
Remote Starting will also cancel if any of the following occur:
When remote start is activated, the heated steering wheel and driver heated seat features will automatically turn on in cold weather. In warm weather, the driver vented seat feature will automatically turn on when the remote start is activated. These features will stay on through the duration of remote start or until the ignition switch is cycled to the ON/RUN position.
The following regulatory statement applies to all radio frequency (RF) devices equipped in this vehicle:
vehicle can be used to start and operate the vehicle. The system cannot reprogram a key fob obtained from another vehicle.
This device complies with Part 15 of the FCC Rules and
After turning the ignition switch to the ON/RUN position,
with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Download Manual