First the car shaked while we were waiting at a traffic light on a city street. then we went to drive into a tunnel and i could not accelerate, we had to roll down the hill to keep moving. then the brakes would not work properly. the car said service brake assist, i had to step very hard on the brake pedal repeatedly to try to stop the car from hitting the car in front of us. once we stopped again the car seemed like it had died. i tried to accelerate by stepping fully on the pedal and nothing. then i put the car in park and tried to turn off the car but that did not work either. it was not until the 3rd time of trying to turn the car off that the vehicle actually turned off. we were able to turn the car back on and at first nothing happened, but then the car started to work again. we found on google that i should not let the car go back into auto-stop in the hope that this would not occur again since we were getting on interstate 95.
Issue> ebrake warning light on i was driving down the road and about 20 miles into my drive the system alerted me of the parking brake or e brake needed to be released. i have not used this brake, but i stop press it all the way in and press again to release. start driving and lime 100ft it dings alerting me again. i press the check button and the warning and brake light go away.. this has been happening for last 5 miles. going to get it checked first thing.
Tl* the contact owns a 2017 chevrolet cruze. the contact stated that the high mount brake lamp failed without warning. the vehicle was taken to buchanan automotive inc (1035 e main st, waynesboro, pa) where it was diagnosed that the washers would need to be replaced. the manufacturer was notified of the failure and was provided case number: 8-3724651728. the failure mileage was approximately 59,238.