We have classified the 3 complaints from 2007 Chevrolet Corvette about SERVICE BRAKES, HYDRAULIC into the following categories.
Tl* the contact owns a 2007 chevrolet corvette. as soon as the contact started the vehicle, the traction control, anti-lock brake system, and service engine soon warning indicators illuminated. the vehicle was not taken to the dealer or an independent mechanic. the manufacturer was not notified of the failure. the vehicle was not repaired. the approximate failure mileage was 36,000. ..updated 09/11/17 *bf *tr
Tl* the contact owns a 2007 chevrolet corvette. while driving various speeds, the traction control system warning indicator and other warning indicators on the instrument panel flashed. the vehicle lost power and decelerated. the failure would correct itself after several minutes and the vehicle would operate normally. the vehicle was taken to royal chevrolet (4502 w broad st, richmond, va 23230 (804) 441-9393) where it was diagnosed with a faulty wheel speed traction detector that needed replacement. the vehicle was not repaired. the manufacturer was notified of the failure and referred the contact to nhtsa. the failure mileage was approximately 68,100.
Driving along and car starts swerving and brakes seem to apply, then i notice service abs, service traction control and service active handling is on. this has been happening frequently for several months and now getting worse. have tightened all connections by internally tightening the poor loose connectors and rerouting the wires to the swps to give more length. now lights are on and will not go out, shows no codes with a scan reader. this is an 07 and i do not see that as a recall even though it is the same problems as the 05 & 06. *tr
On sharp turns, front right brake pulses and temporarily loss of steering occurs. service active handling message appears on dic. very dangerous. **tt
2007 corvette 41,000 miles. "service active handling systems" keeps coming on.. on the dic. when this happens the brake lights get stuck in the "on position" i have almost been rear ended twice because of this. i have had the swps and brake switch replaced twice. i have had the brake switch recalibrated and i have installed the orange comb gm used on the sw wiring harness. still not fixed . updated 03/03/11 *bf *tr
This problem started soon after i purchased the car used. i have replaced the brake switch and added four inches of wire to the wiring harness to the telescopic steering wheel. i recently replaced the brake pads and the service handling system soon comes on. there is no recalls on my car and have been to the dealer about the problem and they can't figure it out. i am reading this could be a serious problem and can cause an accident. i have been to the corvette forum and tried numerous things to fix this. i am currently checking electrical grounds to see if that helps. *tr
Tl* the contact owns a 2007 chevrolet corvette. the vehicle has metal brake and clutch pedals. during rainy weather conditions the components become very slippery. on one incident the failure almost caused a vehicle crash. the dealer and manufacturer were notified. he was advised that the failure was a normal characteristic of the vehicle. he was then advised that a warranty could not be provided. the failure and current mileages were 12,000.