We have classified the 2 complaints from 2013 Chevrolet Camaro about EXTERIOR LIGHTING into the following categories.
Tl* the contact owns a 2013 chevrolet camaro. while operating the vehicle, the turn signals failed to operate intermittently. the vehicle was not diagnosed or repaired. denecker chevrolet(510 us-7, middlebury, vt) was notified of the failure. the vin was not available. the manufacturer was not notified. the failure mileage was 36,000. the vin was unknown.
The high mount led brake light is mounted on the rear windshield at an angle that receives direct heat from the sun causing a slim crack on the brake led board. the crack will shift back and forth sometimes illuminating when braking but at times the slim crack on the led board will prevent the lamp from illuminating causing an immediate safety hazard to passengers of insufficient brake notification to traffic following behind. a replacement led lamp will suffer the same fate based on the angle of the lamp positioned facing the direct heat of the sun. i was in motion and pulled over by le because the lamp was out but worked intermittently while the officer and i tested it. mechanics inspected the lamp and found the slim crack on the led board that allowed shifting of contacts. dealerships have reported this slim crack on the led board as a common problem due to the intense heat of the sun bearing down on the led lamp which is angled out with no visor.
The factory radio turns off and on with blinking lights on the radio itself along with the a/c unit shutting down and back up. the turn signal also do not make any sound. sometimes, if i turn-off the car and pull the key out and back in and crack everthing returns as normal. all the research i've done points to the radio. they just replace it with a aftermarket. they do not make my radio any more. should be a recall on this device.