We have classified the 1 complaints from 2003 Acura CL about SERVICE BRAKES, HYDRAULIC into the following categories.
Brake caliper mount/bracket developed superficial corrosion which reduced the tolerance for the brake pad,s making them resistant to sliding--bound. brake pads adhered to chrome bearing material between pad and caliper bracket, and bearing material, acted like a return spring increasing the tolerances to the rotor when brake pressure released. upon emergency braking, brake pedal travel was excessive, and an accident was narrowly avoided. corrosion was machined from caliper mount/bracket and weather resistant lubricant applied. pads and shims were original manufacturer parts. acura cl 2003. *ak
I purchased a new acura 3.2cl type s with a 6 speed manual transmission on 5/24/03. in 6/16/04 with 14,396 miles i had to have the front rotors resurfaced and my brake pads replaced with updated pads per tsb01-017 because of extreme vibration while braking (out of round rotors due to over heating). this was done at no charge under warranty. on 4/26/05 (less than one year later) with 26,097 miles, acura resurfaced the rotor as a "good will gesture" at no charge because of extreme vibration while braking again. i was advised that the next time i would have to pay for the repairs. now 10/25/06 with 34,500 miles i'm replacing the brake rotors and pads with brembo rotors and pads not oem because of the same reason. in 2004 acura tl's with manual transmissions had bigger rotors and pads. probably to correct the design problem that surfaced with 2003 manuals. *nm
When brakes are applied vehicle drags and front vibrates. contacted dealer, dealer replaced rotors/pads; but problem still occurring. *ak the consumer stated that the front and rear rotors and pads failed and were replaced. the problem still occurs intermittently. *yh