We have classified the 174 complaints from 2006 Jeep Liberty about FUEL SYSTEM, GASOLINE into the following categories.
Tl* the contact owns a 2006 jeep liberty. the contact received notification of nhtsa campaign number: 13v252000 (fuel system, gasoline, structure). the contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. lithia toyota of klamath falls (2675 washburn way, klamath falls, or 97603, (541) 205-4504) was contacted and confirmed that parts were not available for the recall remedy. the manufacturer was not made aware of the issue. the contact had not experienced a failure. parts distribution disconnect.
Tl* the contact owns a 2006 jeep liberty. the contact received notification of nhtsa campaign numbers: 13v252000 (fuel system, gasoline, structure) and 18v278000 (suspension). the contact stated that the manufacturer exceeded a reasonable amount of time for the recall repairs. neuwirth chrysler wilmington (219 s college rd, wilmington, nc 28403, (910) 799-1815) was contacted and confirmed that the parts were not available. the manufacturer was made aware of the issue and was not able to confirm when the parts were to become available. the contact had not experienced a failure. vin tool confirms parts not available.
Tl* the contact owns a 2006 jeep liberty. for the last couple of years, while fueling the vehicle, the fuel would spew back out. the vehicle was taken to findlay chrysler jeep dodge ram post falls (550 n alberta st, post falls, id 83854, (208) 457-1900) where it was diagnosed that the fuel tank and fuel filler neck needed to be replaced. the vehicle was not repaired. the manufacturer was notified of the failure and referred the contact to nhtsa. the approximate failure mileage was 60,000. *bf the consumer stated the fuel spills everytime the vehicle is filled on full speed. *tr
2006 jeep liberty. consumer writes in regards to dealerships failure to respond in a timely manner to rear structure reinforcement recall notice. *smd the consumer was informed the parts were not available. *jb
On september 2, 2015 i brought my 2006 jeep liberty in to a dealership, benson chrysler, in greer sc for a rear structure reinforcement recall repair. after being left at the dealership for 4.5 hours, i was informed that the recall repair could not be completed due to a large amount of rust on the bolts. i was told by the manager, brad that more than one technician look at the car and determined it could not be repaired. i left the dealership in despair with major concern because the recall involves a chance of the jeep fuel tank leaking during a rear end collision which could result in a fire. now as a mother and wife i cannot imagine continuing to drive the vehicle knowing the at any given time i could lose my car and possibly the life of me and my family. please help me by addressing the issue of how chrysler plan to handle this recall. i strongly feel it should not be ignored by suggesting me to continue driving a vehicle that pose such a great danger . your attention is greatly appreciated. updated ...
2006 jeep liberty. consumer writes in regards to no replacement parts to complete fuel tank recall notice. *smd
2006 jeep liberty. consumer writes in regards to gas tank recall issues. *smd the consumer stated he has been getting the run-a-around from chrysler with trying to get the recall performed. the consumer had an after market tow hitch installed on the vehicle. however, he was informed it was unfit/unsafe. *jb updated 10/27/15.*jb
2006 jeep liberty. consumer writes in regards to the rear structure reinforcement recall repairs issues. *smd the consumer stated the recall worked was done rather quickly, despite being informed the work would take fours to complete. *jb
2006 jeep liberty. consumer writes in regards to rear structure reinforcement recall notice. *smd the consumer stated each time he went to the dealer, he was informed the parts were not available. *jb
Tl* the contact owns a 2006 jeep liberty. the contact received a notification for nhtsa campaign id number: 13v252000 (fuel system, gasoline, structure) and stated that the part needed was unavailable to repair the vehicle. the dealer was unable to inform when the part would become available. the manufacturer was not notified of the issue. the contact had not experienced a failure.
Tl* the contact owns a 2006 jeep liberty. the contact received a recall notification for nhtsa campaign number: 13v252000 (fuel system, gasoline, structure) and stated that the part needed was unavailable to perform the recall repair. the manufacturer was not notified of the issue. the vin was unavailable. the contact had not experienced a failure.
Tl* the contact owns a 2006 jeep liberty. the contact received notification of nhtsa campaign number: 13v252000 (fuel system, gasoline, structure) and stated that the part was not available for several months. the dealer did not give a specific date for when the part would become available. the manufacturer was contacted and could not provide an estimated date for when the contacts vehicle would receive the recall repair. the contact had not experienced a failure. updated 7/13/15*cn
When filling the vehicle, fuel comes splashing out of the filler neck all over the side of the vehicle and possibly anyone standing too close. i feel this is a huge safety issue as the amount of fuel and vapors splashed out is a big fire risk. does someone need to be badly burnt or killed before this gets fixed? *tr
Tl* the contact owns a 2006 jeep liberty. the contact received notification of nhtsa campaign id number: 13v252000 (fuel system, gasoline, structure) and stated that the part needed was unavailable to repair the vehicle. the dealer was unable to specify when the part would become available. the manufacturer was not notified of the issue. the contact had not experienced a failure. updated 12/19/14*cn the recall was completed on december 8, 2014. updated 01/08/15
Tl* the contact owns a 2006 jeep liberty. the contact received a notice for nhtsa campaign id number: 13v252000 (fuel system, gasoline, structure) and stated that the part needed was unavailable to perform the repair. the vin was unavailable. the manufacturer was not notified of the issue. the contact had not experienced a failure.